SNOITCENNOCGULPROTCENNOCREKAMECI
rebmuNeriWroloCeriW:otstcennoC
1wolleY/neerGdnuorG
2wolleYevlaVretaW
3kcalBeniL
4eulB.tLlartueN
ATADECNAMROFREP
GNITTESLORTNOCTNIOP-DIMTASGNINEPOROODONDNADAOLON
roticapaCtratS/nuRhtiWAepyTtneibmA)C°81(F°56 tneibmA)C°23(F°09
emiTgnitarepO%04ot23%56ot55
erutarepmeTrezeerFF°4ot°0
C°61-ot°81-
F°3ot°1-
C°61-ot°81-
erutarepmeTrotaregirfeRF°93ot°43
C°4ot°1
F°93ot°43
C°4ot°1
(erusserPediSwoL
)ni-tuc
gisp21ot5
aPk38ot43
gisp21ot5
aPk38ot43
(erusserPediSwoL
)tuo-tuc
gisp2ot2-
aPk41ot41-
gisp2ot2-
aPk41ot41-
(erusserPediShgiH
)elcycfo3/1tsaL
gisp511ot09
aPk397ot126
gisp551ot031
aPk9601ot698
)elcycfo3/1tsaL(egattaW051ot021061ot031
)gninnuR(spmA5.1ot2.15.1ot2.1
egatloVesaB)xamcav721(cav511)xamcav721(cav511
SNOITACIFICEPSTSORFED
eziStenibaC
tatsomrehTretaeH
ni-tuCtuo-tuCsttaWsmhO
'62&'32F°52
C°4-
F°74
C°8
05403
.emitnurrosserpmocfosruoh27ot6yrevesetunim42tsorfeD)CDA(-remiTcinortcelE
ROTOMNAFRESNEDNOC
sttaWMPRspmA
7tfahSetisoppOWC0011gninnuR1.
SNOITACIFICEPSREKAMECI
lacirtcelE)xamcav721(cav511ztreH06
tatsomrehT)C°9(F°84tasnepO)C°9-(F°51tasesolC
egattaWretaeH561
ICE MAKER INFORMATION
Test Cycling
Remove cover by inserting screwdriver in notch at bottom and prying
cover from housing. Use screwdriver to rotate motor gear
counterclockwise until holding switch circuit is completed. All
components of ice maker should function to complete the cycle.
Water Fill Volume
The water fill adjustment
screw will change the fill
time. One full turn is
equal to 20cc (.68 oz.).
The correct fill is 102 to
130cc (3.4 to 4.3 oz.).
When a water valve is
replaced, the fill volume
must be checked.
SERVICE DATA SHEET - 240389612
R134a
ICE & WATER - AUTOMATIC DEFROST
SIDE BY SIDE MODELS
IMPORTANT SAFETY NOTICE
The information provided herein is designed to assist qualified repair
personnel only. Untrained persons should not attempt to make
repairs due to the possibility of electrical shock. Disconnect power
cord before servicing.
IMPORTANT
If any green grounding wires are moved during servicing, they
must be returned to their original position and properly secured.
CAUTION: All electrical parts and wiring must be shielded
from torch flame. Do not allow torch to contact insulation; it
will char at 200°F and flash ignite (burn) at 500°F. Excessive
heat will distort the plastic liner.
NOTE: This product comes equipped with an Electronic Defrost
Control. To initiate defrost, depress the fresh food light switch 5
times in 6 seconds (light bulb must be working). To terminate
defrost, depress the fresh food light switch 5 times in 6 seconds.
