FSL Scoreboards C01-9 User manual

C01-9

C01-9
1)
Scoreboard connections:
•
The scoreboard should be supplied with a 230V mains supply.
•
The mains supply should be fed through
and it is highly recommended that the supply should be fed through
a Residual Current Device (RCD)
•
If the scoreboard has been supplied with a separate aerial this
should be mounted as high as possible
2
) Changing Scores
(a) P
ress and release REFRESH/INNINGS
sent to the
scoreboard.
(b) Press and hold
REFRESH/INNINGS
button. The T
otal WICKETS OVERS
whatever the
Total was.
(c) Press and hold
REFRESH/INNINGS
flashes to make all 0.
(d
) To change scoreboard press
times & then release -
(e) At any time, pressi
n
all data again.
Scoreboard connections:
The scoreboard should be supplied with a 230V mains supply.
The mains supply should be fed through
a 5 A
mp circuit breaker
and it is highly recommended that the supply should be fed through
a Residual Current Device (RCD)
.
If the scoreboard has been supplied with a separate aerial this
should be mounted as high as possible
.
) Changing Scores
:
ress and release REFRESH/INNINGS
-
current stored info is
scoreboard.
REFRESH/INNINGS
until led flashes
otal WICKETS OVERS
set to 0 and 1st Inns to
Total was.
REFRESH/INNINGS
for second time
) To change scoreboard press
keys required number of
wait until the data sent.
n
g the REFRESH/INNINGS
briefly
Page 2 of 4
The scoreboard should be supplied with a 230V mains supply.
mp circuit breaker
and it is highly recommended that the supply should be fed through
If the scoreboard has been supplied with a separate aerial this
current stored info is
until led flashes
- release
set to 0 and 1st Inns to
for second time
until led
keys required number of
briefly
will resend

C01-9 Page 3 of 4

C01-9
FSL ELECTRONICS LTD
SANDHOLES ROAD
COOKSTOWN
CO TYRONE
N. IRELAND
BT80 9AR
[phone]
www.fslelectronics
Page 4 of 4