FSL Scoreboards M01 User manual

M01

M02 without Clock Page 2 of 8
1) Scoreboard connections:
The scoreboard should be supplied with a 230V mains supply.
The mains supply should be fed through a 5 amp circuit breaker
and it is highly recommended that the supply should be fed through
a Residual Current Device (RCD)
If the scoreboard has been supplied with a separate aerial this
should be mounted as high as possible
2) On Power Up:
'Cd - ' will be displayed for 5 seconds
oThis is a "code" number stored in memory
oThere are 5 possible codes that may be used, this
allows a number of displays to be operated in close
proximity of each other
oFurther details on programming the code can be
found at the end of the manual
The scoreboard will now go into normal operation, displaying
scores with the clock blanked.

M02 without Clock Page 3 of 8
3) Changing Scores:
1. To increase the score press the
button
2. To decrease the score press the button

M02 without Clock Page 4 of 8
3. To clear the score press the &
button together

M02 without Clock Page 5 of 8
4) Brightness Setting:
To access brightness setting, hold buttons & on the
handset together for 3 seconds until 'bl - ' is displayed
To exit brightness setting, hold buttons & on the
handset together for 3 seconds until the scores are displayed again

M02 without Clock Page 6 of 8
Increasing Brightness:
While 'bl - ' is displayed, increase brightness with button
The maximum brightness is 9
Decreasing Brightness:
While 'bl - ' is displayed, decrease brightness with button
The minimum brightness is 0
To exit brightness setting, hold buttons & on the
handset together for 3 seconds until the scores are displayed again

M02 without Clock Page 7 of 8
6) Scoreboard Blank:

M02 without Clock Page 8 of 8
FSL ELECTRONICS LTD
SANDHOLES ROAD
COOKSTOWN
CO TYRONE
N. IRELAND
BT80 9AR
[phone]
www.fslelectronics