Fujikura 41S Setup guide

Ⓒ2018 Fujikura Ltd.
How to set to rotate the blade automatically by detecting worn blade
Bluetooth communication between Fujikura fusion splicers and cleavers provides a useful
function.
Cleaver blade rotates automatically by detecting worn blade.
This document shows example in case of 41S and CT50 combination.
1. Open Bluetooth setting menu and set [Splicer] and [Cleaver] to ON
2. Cleaver setting window appears in READY screen. If not appears, turn off and restart.
3. Open Bluetooth setting menu and pair with CT50
4. Set each [Blade Position Change], [Blade Height Change] and [Blade Replacement] to
ON.
SPLICING TIPS
No.6004
Nov-2018

Ⓒ2018 Fujikura Ltd.
5. Set blade alarm function by one of the following method
(1) Set [Blade Alarm Detection] to [Image Analysis]
(2) Set [Blade Rotation Link To Alarm] to [Auto Without Confirmation] or [Manual With
Confirmation]
At that time, it is automatically changed [Blade Alarm Detection] to [Image Analysis].
Auto Without Confirmation
When the splicer detect the cleaver blade worn, rotate
the cleaver blade automatically without any confirmation.
Manual With Confirmation
When the splicer detect the cleaver blade worn, show the
message whether change the blade position.
6. [Number of Cleaving Errors] and [Number of Cleaves] appear.
You can avail auto blade rotating function.
In this case, the splicer rotates the blade if the splicer detects error 3 times in last 10 times
gap set.
+++Issued by Engineering Division of Fusion Splicer Department+++