Full Spectrum Solutions UltraLux Serenity User manual
Dear Customer,
Congratulations, you have just purchased a quality full spectrum light fixture from Full Spectrum Solutions, Inc. Your lamp has been
produced with the finest components available.
Be sure to retain your receipt and original packaging for warranty purposes. If you have a warranty claim or you have a question about the
product, please contact the dealer where you purchased your light. If you purchased from Full Spectrum Solutions, Inc., please email
[email protected] call 1-888-574-7014 with any questions.
Assembly and Start Up:
Before you start
Never assemble or disassemble the fixture with the power cord plugged into a power supply.
Carefully remove from the package and inspect all the parts and lay them out on the floor. Parts include: bulb, decorative collar (A), glass
bowl (B), base and pole (C) and threaded stem (D) with bowl washer. Handle the glass bowl (B) section with care.
Step 1: Install the Bulb
Carefully hold the bulb by the plastic section located on the side of the bulb. Insert the 4-pin plug attached to the top of the lamp into the
socket on the plastic section on the bulb. Be sure that the connection is secure. Insert the three metal bracket bulb holders into the
interior diameter of smaller circle of the bulb. Important: The smaller circle of the bulb must be on top per the illustration. Do
not install the bulb upside down, as this could cause the metal brackets to break.
Step 2: Attach the Threaded Stem, Bowl & Decorative Collar
Screw the threaded stem (D) with the bowl washer onto the ballast. Place the glass bowl (B) onto the threaded stem (D) (centered on the
bowl washer). Securely screw the decorative collar (A) onto the top of the threaded stem (D). Do not over-tighten the decorative collar
(A).
Operation - Your UltraLux lamp is now ready for use. Plug into any power outlet and turn the switch to the desired level of light. The
plug on the unit is polarized and the larger metal pin must be placed in the matching wall outlet slot. Please note, fluorescent bulbs can
take up to 1 minute to reach their full brightness due to the need for a warm-up period. For best results, leave the bulb on high for the first
two hours of operation prior to dimming.
NOTE: DO NOT ATTEMPT TO REMOVE THE WHITE SILICON MATERIAL OR PLASTIC MATERIAL BETWEEN THE CIRCULAR
TUBES OF THE LIGHT BULBS. THIS MATERIAL IS IN PLACE TO PROVIDE STABILITY AND IS NOT A FIRE HAZARD.
Full Spectrum Solutions, Inc. 888-574-7014
TM
UltraLux Serenity Table Lamp
TM
Table of contents
Other Full Spectrum Solutions Home Lighting manuals
