FURNA E1 User manual

FURNA E1
ASSEMBLY GUIDE
MODEL FNAE1FRM18XXX

PARTS & TOOLS LIST
2
1 8 9
10 11 12 13 14
15 16
7
3
4
5
6
NO Name Qty NO Name Qty
1 Support Beam 1 9 Axle 1set
2 Foot Pad 4 10 2.5mm Hex Spanner 1
3 Foot Margin 2 11 4mm Hex Spanner 1
4 M8x16 Screw 8 12 5mm Hex Spanner 1
5 Bracket 2 13 Rubber Cushion 8
6 M6x14 Screw 16 14 Spanner 1
7 Lifting System 1set 15 ST3 5x19 Screw 2
8 M8x14 Screw 16 16 ST4 8x19 Screw 10

STEP 1
STEP 2
Loosen the 4 screws using the hex
spanner, so the frame can adjust
to the desk top size as/when needed
Attach legs to the support beams
using the parts shown
4mm Hex spanner
M6x14 8pcs

STEP 3
STEP 4
Attach the feet and then the foot
levelling pads
Switch the frame to the upright
position and attach the top support
brackets
4mm Hex spanner
8x16 screw 8pcs
Foot pad 4pcs
4mm Hex spanner
Rubber Cushion 6pcs
6x12 screw 4pcs

STEP 5
STEP 6
Loosen the nut on each end of the
axle (Part 9) and insert the inner hex-
shaped rods into both legs. Once fully
inserted into both, tighten the nuts on
the Part 9 axle
Put the frame upside down onto
the desk top in a centered position.
Adjust the frame width to suit the
desk top (we suggest around 5cm
from each side)
Once in position, tighten the
M6x10 screws (Part 8) to set the
frame width
Main Leg
Nut
1cm
There is a 1cm gap between
the nut and metal plate.
3-5cm
(recommended)

STEP 7
STEP 8
Screw in the frame and control box to
the under side of the desk top as
shown using Part 16 (larger) wood
screws. Position of control box is
exible based on preference though
usually goes in the position shown, or
further towards the back of the desk
(when standing upright)
Once in position, tighten the
M6x10 screws to set the frame width
and screw in the control panel on the
front, under side of the desk top using
Part 15 wood screws
Make sure all screws and bolts are
tight, then plug in cables as shown
and your desk is ready to be used!

Need help?
Get in touch by emailing [e-mail] or
by using our Live Chat feature on our website!