Fusion 24732 User manual
10 PIECE SOLAR PINEAPPLE
STRING LIGHTS
model no. 24732
Assembly Instructions
IMPORTANT: Please read this manual carefully
before beginning assembly of this product.
Keep this manual for future reference.
2
IMPORTANT INFORMATION
model no. 24732
Getting Started
Please do not throw away any packing material until all parts are verified as present.
Important
• Fully charge the battery before first use.
• For best results, locate your solar lamp in a position where it can get direct sunlight on the solar panel and is generally free from
cover and shade.
• Keep your solar lights away from other nighttime light sources, such as streetlights.
• Make sure the solar panels are not covered by dust, snow and debris. Clean it with a soft damp cloth or paper towel periodically.
Avoid the use of abrasive cleaning agents.
• Use only rechargeable batteries for your solar lights. Replace with a new battery of the same size each year for optimum
performance.
Overview
This product is designed to the highest technical specifications and standards. It will supply years of maintenance-free use.
Please read these instructions thoroughly prior to installation, then store in a safe place for future reference.
About Your Solar Light
During the day your solar panel will convert the sun’s light and/or UV rays into electrical power that will charge the rechargeable
battery. When it becomes dark, the solar light will turn on using the power stored in the rechargeable battery as it will detect no
daylight. The unit’s light output strength and duration depends on how many hours and how much sunlight and/or UV rays your
panel absorbs throughout the day.
For maximum output place the solar panel in an area where there is direct sunlight for at least 8 hours in a given day. Do not
install your solar light in a shaded area. The selected location should not be near nighttime light sources such as porch lights,
street lights or pool lights, as these may cause the solar light to turn off prematurely.
3
OPERATIONBATTERY REPLACEMENT
Battery Replacement
Step 1: Push the ON/OFF switch to turn off.
Step 2: Remove the screws from the battery compartment cover.
Step 3: Replace the battery with an equivalent, new solar
rechargeable Ni-MH battery, ensuring the correct polarity is
observed.
Step 4: Reassemble the unit by reversing the above procedure.
Step 5: Push the ON/OFF switch to turn on. Allow the
unit to fully charge in direct sunlight for up to 2 days in
the ON position. Once fully charged, your solar light will
automatically turn on once it gets dark.
CAUTION: Rechargeable batteries contain nickel-cadmium
or nickel-metal hydride and must be recylced or disposed
of properly. Do not mix old and new batteries. Do not mix
alkaline, standard (carbon-zinc), or rechargeable batteries.
Do not dispose of batteries in fire. Batteries may explode or
leak.
For First Time Use
Step 1: If there is a protective film covering the solar panel, this
must be removed prior to use.
Step 2: Push the ON/OFF switch to turn on. Allow the
unit to fully charge in direct sunlight for up to 2 days in
the ON position. Once fully charged, your solar light will
automatically turn on once it gets dark.
Care Information
1. Clean any dirt and debris from the solar panel. The panel cannot recharge if the light is obstructed. Use a soft cloth to clean the
panel. Do not use abrasives or chemicals that might scratch or damage the UV coating.
2. In a region where snow and ice are likely and the light assembly is covered with snow for an extended period of time the
batteries will require a recharge for at least 8 hours.
3. To prolong the life of the product, it is recommended to store the product indoors during the winter months. Remove the batteries
and store in a dry location.
MAINTENANCE
WARRANTY
4
Troubleshooting Tips
If your solar light does not come on at dusk despite following all instructions please try the following steps:
1. Make sure that the solar light is not affected by any other light source.
2. Ensure the solar light does not stand in the shade all day.
3. Check to see if the batteries are installed correctly.
4. Battery may need to be replaced.
model no. 24732
1-Year Limited Product Warranty
This product is covered under a one year limited warranty. Fusion Products Ltd. warrants to the original purchaser that this product
is free from defects in materials and workmanship for the period of one year from date of purchase.
For Technical Support and/or Warranty inquiries please contact:
Fusion Products Ltd.
Monday to Friday
8:00-4:00 PM EST
5 Cherry Blossom Road, Unit 7
Cambridge, Ontario N3H 4R7
Tel: 1-877-615-1378 Fax: (519) 650-0202
Website: www.fusionproducts.ca
Table of contents
