Gaggenau BS 470 612 User manual

*DJJHQDX
Installation instructions2
Notice de montage15
Instrucciones de instalación28
BS 470/471 612
BS 474/475 612
BS 484/485 612
Combi-steam oven
Four combi-vapeur
Horno combinado de vapor

2
en-us
Table of Contents
Installation instructions
9Safety Definitions 2
IMPORTANT SAFETY INSTRUCTIONS 3
Appliance Handling Safety 3
Safety Codes and Standards 3
Electric Safety 4
Related Equipment Safety 4
Proposition 65 Warning 4
Transport 5
Before you begin 6
Tools and Parts Needed 6
Parts Included 6
Power Requirements 6
Planning Notes 6
Preparing Kitchen Units 6
Dimensions and Cabinet Requirements 7
General Cabinet Requirements 7
Appliance Dimensions 7
Cabinet Dimensions 8
Removing Packaging 9
Connection to the home network (LAN) 9
Water connection 9
Waste water connection 9
Install Appliance 10
Mount to Cabinet 10
Adjusting the door 11
Three wire connection 12
Combination with an oven 12
Combination with warming drawer, width 24" (60 cm) 14
Combination with warming drawer, width 30" (76 cm) 14
Check the Installation 14
Removal 14
4 Customer service 14
9Safety Definitions
SafetyDefinitions 9WARNING
This indicates that death or serious injuries may
occur as a result of non-observance of this
warning.
9CAUTION
This indicates that minor or moderate injuries may
occur as a result of non-observance of this
warning.
NOTICE
This indicates that damage to the appliance or property
may occur as a result of non-compliance with this
advisory.
Note: This alerts you to important information and/or
tips.

3
9IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
READANDSAVETHESEINSTRUCTIONS IMPORTANT SAFEGUARDS
SAVE THESE INSTRUCTIONS.
9WARNING
If the information in this manual is
not followed exactly, fire or shock
may result causing property damage
or personal injury.
9WARNING
Do not repair, replace or remove any
part of the appliance unless
specifically recommended in the
manuals. Improper installation,
service or maintenance can cause
injury or property damage. Refer to
this manual for guidance. All other
servicing should be done by an
authorized service provider.
This appliance is intended for use up to a
maximum height of 13,100 feet
(4,000 meters) above sea level.
Appliance Handling Safety
Unit is heavy and requires at least two
people or proper equipment to move.
Do not lift appliance by door handle.
Safety Codes and Standards
This appliance complies with the latest
version of one or more of the following
standards:
▯CAN/CSA-C22.2 No. 60335-1 Safety of
Household and Similar Electrical
Appliances - Part 1: General
Requirements
▯CAN/CSA C22.2 No. 60335-2-6
Household and similar electrical
appliances – Safety – Part 2-6:
Particular requirements for stationary
cooking ranges, hobs, ovens and
similar appliances
▯UL 858 - Household Electric Ranges
▯CAN/CSA C22.2 No. 150 - Microwave
Ovens
▯UL 923 - Microwave Cooking
Appliances
▯CSA C22.2 No. 64 - Household
Cooking and Liquid-Heating
Appliances
▯UL 1026 - Electric Household Cooking
and Food Serving Appliances
It is the responsibility of the owner and
the installer to determine if additional
Hidden surfaces may have sharp
edges. Use caution when
reaching behind or under
appliance.

9IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
4
requirements and/or standards apply to
specific installations.
Electric Safety
9WARNING
Before you plug in an electrical cord
or turn on power supply, make sure
all controls are in the OFF position.
If required by the National Electrical
Code (or Canadian Electrical Code), this
appliance must be installed on a separate
branch circuit.
Installer – show the owner the location of
the circuit breaker or fuse. Mark it for
easy reference.
INSTALLER: LEAVE THESE
INSTRUCTIONS WITH THE APPLIANCE
AFTER INSTALLATION IS COMPLETE.
IMPORTANT: SAVE THESE
INSTRUCTIONS FOR THE LOCAL
ELECTRICAL INSPECTOR'S USE.
Before installing, turn power OFF at the
service panel. Lock service panel to
prevent power from being turned ON
accidentally.
Refer to data plate for more information.
See “Data Plate” under “Service” for data
plate location.
Be sure your appliance is properly
installed and grounded by a qualified
technician. Installation, electrical
connections and grounding must comply
with all applicable codes.
Related Equipment Safety
Remove all tape and packaging before
using the appliance. Destroy the
packaging after unpacking the appliance.
Never allow children to play with
packaging material
Never modify or alter the construction of
the appliance. For example, do not
remove leveling legs, panels, wire covers
or anti-tip brackets/screws.
Before starting up the appliance, remove
any packaging material and adhesive film
from the cooking compartment and the
door.
Proposition 65 Warning:
This product may contain a chemical
known to the State of California, which
can cause cancer or reproductive harm.
Therefore, the packaging of your product
may bear the following label as required
by California:

&DQFHUDQG5HSURGXFWLYH+DUPZZZ3:DUQLQJVFDJRY
67$7(2)&$/,)251,$352326,7,21:$51,1*
:$51,1*

5
9IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
Transport
To avoid damage to the oven vent, use the
transport method shown in the picture
below.

6
en-us Before you begin
Before you begin
Beforeyoubegin Tools and Parts Needed
▯Philips head screwdriver
▯1/8" drill bit and drill
▯Measuring tape
Parts Included
▯Combi-steam oven
▯1 Torx screw
Power Requirements
The outlet must be properly grounded in accordance with
all applicable codes.
Planning Notes
Door hinge not interchangeable.
Distance from furniture body to door front 1.85” (47 mm).
Pay attention to the front protrusion, possibly including
the door handle, for opening drawers at the sides.
When planning a corner solution, pay attention to the
door opening angle of at least 90°.
No other electrical appliance may be integrated into the
cupboard above this appliance.
Do not install the appliance version with the control panel
on the bottom above a dishwasher. Ascending steam from
the dishwasher can damage the appliance electronics.
Preparing Kitchen Units
Prepari ngKitchenUnits Units into which ovens are to be fitted must be heat-
resistant up to 195°F (90°C) and adjacent cabinets up to
160°F (70°C).
Connection box must be outside of the installation niche.
Perform cut-out work on the furniture before inserting the
appliance. Remove any shavings or the function of the
electrical components may be impaired.
Secure freestanding units to the wall using a standard
bracket.
Only fit the appliance up to a height that allows
accessories to be removed easily.

7
Preparing Kitchen Units en-us
Dimensions and Cabinet Requirements
General Cabinet Requirements
Cabinet requirements vary depending on the model to be
installed. Please consult the section “Dimensions” for the
details pertaining to your particular model.
All models require:
▯¼" (6.4 mm) space between the side of the appliance
and an adjacent wall or cabinet door when installed at
the end of a cabinet run.
▯The cabinet base must be flat and capable of
supporting the weight of your appliance when in use.
See the appropriate weight for your model in the
“Dimensions” section pertaining to your particular
model.
NOTICE
The appliance must not be installed behind a
decorative door in order to avoid overheating.
Appliance Dimensions
%6
é



 PP
ë

é



 PP é



ë

é



%6
 PP é



ë



ʌ¼ʚ

%6

8
en-us Preparing Kitchen Units
Cabinet Dimensions
NOTICE
The cabinet base must be flat and capable of supporting
a weight of at least 102 lbs (46 kg).
NOTICE
The cabinet base must be flat and capable of supporting
a weight of at least 115 lbs (52.1 kg).

/$1
%6
%6
 PP




é







ʌ¼ʚ

ë



é

/$1


%6
é



 PP


ʌ¼ʚ




ë


ʌ¼ʚ







9
Preparing Kitchen Units en-us
Removing Packaging
NOTICE
To prevent damage to your floor keep the unit in its
packaging base until ready to be placed in the cabinet
opening. Do not slide the unit across the flooring.
Different models use different packaging materials.
Actual brackets may look differently. Bracket remains in
packaging base.
1. Cut straps on outside of box.
2. Remove cardboard box.
3. Remove all top and side cardboard and Styrofoam
braces.
4. Place oven in front of cabinets where it is to be
installed.
Connection to the home network (LAN)
This appliance is network-compatible and can be
connected to the home network using a LAN cable (LAN
cable not included). Before installation, plug the LAN
cable into the socket on the rear of the appliance and
secure it using the strain relief. Connect the LAN cable
to a network socket.
Water connection
The appliance is backflow-proof (VDE tested).
Connection valves with backflow preventers are not
required. Follow the regulations of the local water utility.
Install a suitable descaling system in front of the
appliance if the water hardness exceeds 7 dH.
Maximum rated water pressure: 1 MPa (10 bar)
Only connect the appliance to a cold-water
connection:
▯Connection ¾" (26.4 mm)
▯Maximum inlet water pressure: 1 MPa (10 bar)
▯Minimum inlet water pressure: 0.2 MPa (2 bar)
▯Min. 2.6 gal (10 liters)/minute
Note: The water connection for the supply hose must
always be accessible (not directly behind the appliance).
Waste water connection
Provide for an odor trap on the drain connection. The
connection on the odor trap must always be accessible
(not directly behind the appliance).
Important notes on the drain hose
▯Do not fit the drain hose at any point higher than the
bottom edge of the appliance
▯Drain: at least ø1½" (38 mm) inner diameter
▯Drain connection: at least 4" (100 mm) lower than the
appliance drain
▯Do not kink the drain hose
▯Do not shorten the included drain hose
▯Drain hose: no more than 5.5 yards (5 m) long

10
en-us Preparing Kitchen Units
Install Appliance
Note: The appliance is heavy. It is advisable to install it
with a second person.
NOTICE
Before installing the appliance, be sure to verify the
cabinet dimensions and electrical connections.
Mount to Cabinet
▯When installing two appliances next to each other:
Both recessed handles must face toward the center.
▯Secure the appliance against tilting in the cupboard if
there is not intermediate shelf above the appliance:
fasten two commercially available brackets on both
sides inside the cupboard (at 17 3/4" (450 mm) deep,
3/16" (5 mm) above appliance height).
▯Before installing, remove the transport brackets for
the supply and drain water hoses.
1. Push the appliance fully into the kitchen unit. Route
the Combi-steam oven's connecting cable and supply
and drain water hoses to the connection points on the
rear left in the kitchen unit.
Do not kink or jam connecting cables and hoses or
route them over sharp edges.
/$1
èç¼ʓʘ 
èʌ¼ʓʘ

ê


è¼ʓʘ 
%6
 PP
%6
è¼ʚ
è¼ʓʘ

ʌ¼ʚ

èʌ¼ʓʘ

ç¼ʓʘ

 PP

èʌ¼ʓʘ

 PP