Gainsborough K219 User manual

Solar Cut Out Leaf Lantern
K219 v001: 11/08/21
Please read and retain these instructions for future reference
Battery: 1 x AAA 1.2v 300MAh, Ni-MH, Rechargeable
ASSEMBLY INSTRUCTIONS / INSTRUCTIONS FOR USE:
Unpack the components carefully. Please check all parts have been removed from the packaging.
Before using first time
Remove the protective film from the solar panel. Allow lantern to charge for at least 8 hours in full sunlight
with the ON/OFF switch in the ON position. The ON/OFF switch is located under the solar panel. Once the
batteries are fully charged, set the ON/OFF switch to ON. If the lamp does not turn on after dark refer to
Maintenance section.
Find an ideal Place for the Solar Light.
1. Install the solar product in an area where it can get direct sunlight.
2. Leave the switch to “ON” position.
3. Select an outdoor location away from other light sources at night, such as street lights. It may cause
the product not to turn on automatically at night.
4. Duration of light depends on solar product’s level of sunlight exposure, geographical locations,
weather conditions and the hours of daylight.
CHARGING AND OPERATION:
1. The solar panel is located under the glass ball. Set switch (at the bottom of the product) to “ON”
position. Press the ON/OFF button to “ON” position. Charge the solar product by placing it under
direct sunlight for at least 8 hours.
2. The light will work automatically. It will charge under direct sunlight during the daytime and
illuminate at night.
TROUBLESHOOTING:
1. Make sure the switch is set to “ON” position.
2. Keep the solar panel clean.
3. If solar product does not light up after it has been used for around 8 –12 months, replace the
rechargeable battery as it may be weak or worn out. (Battery 1 pc “AAA” 1.2v 300Mah, Ni-MH,
Rechargeable–Same equivalent type as recommended must be used).
ALWAYS POSITION IN DIRECT SUNLIGHT
Dimensions
(H) 19.5 x (W) 15.5 x (D) 15.5cm
•POLYCRYSTALLINE SOLAR PANEL 50 MA
•CENTRE PIECE
•CREATES PRETTY SHADOWS

Solar Cut Out Leaf Lantern K219 Instructions for Use
Please read and retain these instructions for future reference v001: 11/08/21
Battery replacement:
Step1: Unscrew the battery compartment cover by using a Phillips head screwdriver (not included) .
Step2: Remove the exhausted battery and install 1x new AAA rechargeable battery according to the +/-
polarity as beside image. Open the compartment carefully and ensure that wire inside the battery terminals
is not damaged.
Step3: Replace battery compartment cover, screw it back into position and make sure is properly sealed.
Care and Maintenance Recommendations
1. Clean solar panel with a soft sponge every couple of weeks.
2. Make sure all connectors are still tight and no water getting in.
3. During the winter if you can bring it inside and give a good clean ready for next year.
4. Protect this solar cut out leaf lantern from rainy / wet conditions so that rain / snow does not build up
inside the cut out leaves.
BATTERIES
•Keep batteries away from children and pets.
•Do not mix used and new batteries.
•Remove the batteries if left for long periods.
•Never dispose of batteries in a fire.
•Battery disposal, spent or expired batteries must be properly disposed of and recycled in compliance
with local regulations. For detailed information, contact your local authority.
•Follow the battery manufacturer’s safety, usage, and disposal instructions.

Solar Cut Out Leaf Lantern K219 Instructions for Use
Please read and retain these instructions for future reference v001: 11/08/21
DISPOSAL
•Coopers of Stortford use recyclable or recycled packaging where possible.
•Please dispose of all packaging, paper, cartons, packaging in accordance with your local
recycling regulations.
•Plastics, polybags –this is made from the following recyclable plastic.
Code & Symbol
Type of Plastic
Polypropylene
Commonly used for
Microwaveable food containers, yoghurt pots, butter tubs, disposable
plates and cups
Notes
Commonly recycled and collected from household recycling bins
(packaging tape itself not recyclable but does not interfere with cardboard)
•At the end of the product’s lifespan please check with your local council authorised household waste
recycling centre for disposal.