Gainsborough H586 User manual

150cm Light Up Acorn Garland
H586 v001: 15/02/21
Please read and retain these instructions for future reference
Always position in direct sunlight
ASSEMBLY INSTRUCTIONS / INSTRUCTIONS FOR USE:
Unpack the components carefully. Please check all parts have been removed from the packaging.
Find an ideal Place for the Solar Light.
Place the solar light in an area where it will receive direct sunlight for at least 8 hours per day. The number of
hours the light will illuminate is directly proportional to the hours of sunlight it receives. If the light is placed
in a shaded area, it will not be able to fully charge and its illumination time will be limited. Do not place the
light near other outdoor lighting like porch or streetlights. These may fool the sensor and keep the light from
coming on, or cause it to turn off automatically
IMPORTANT:
1. Install the solar light in an area where it can get direct sunlight.
2. Leave the button in the “ON” position.
Dimensions
Length: 150cm
Battery: 1x Ni-MH AA 600mAh 1.2V
9 x Warm White LED Lights (not replaceable)
CHARGING AND OPERATION:
1. Firstly, press down button which is on the backside of the solar
panel to “ON” position for charging and charge by placing it in
direct sunlight for at least 8 hours. Secondly, press down the
button again to “OFF” position, the light will be off and stop
charging.
2. The light will work automatically after first pressing the button.
It will charge in direct sunlight during the day time and
illuminate at night.
NOTE: In order to check the solar function, firstly press down the
button; then place the solar panel in the sunlight; finally, cover the
solar panel with your hand and light should turn “ON”
automatically.
ON/OFF

150cm Light Up Acorn Garland H586 Instructions for Use
Please read and retain these instructions for future reference v001: 15/02/21
3. Select an outdoor location away from other light sources at night, such as street lights which may
cause the product not to turn on automatically at night.
4. Duration of light depends on solar product’s level of sunshine exposure, geographical locations,
weather conditions and the hours of daylight.
MAINTENANCE AND TROUBLESHOOTING:
1. Make sure the switch is set to “ON” position.
2. Keep the solar panel clean.
3. If solar product does not light up after it has been used for around 8 –12 months, replace the
rechargeable batteries as they may be weak or worn out. (Battery 1pc “AA” 1.2v 600Mah, Ni-MH,
Rechargeable–Same equivalent type as recommended must be used).
Care and Maintenance Recommendations
1. Clean solar panel with a soft sponge every couple of weeks.
2. Make sure all connectors are still tight and no water getting in.
3. During the winter if you can bring it inside and give a good clean ready for next year.
BATTERY REPLACEMENT:
Step1: The battery compartment is located underneath the solar panel. Remove battery compartment cover
by using a small Phillips head screwdriver (not included) .
Step2: Remove the exhausted battery and install 1pc new AA rechargeable battery according to the polarity
symbol indicated on the battery compartment. Open the compartment carefully and ensure that welding
wires inside the battery terminals are not damaged.
Step3: Replace battery compartment cover, screw it back into position and make sure it is properly sealed.
BATTERIES
•Keep batteries away from children and pets.
•Do not mix used and new batteries.
•Remove the batteries if left for long periods.
•Never dispose of batteries in a fire.
•Battery disposal, spent or expired batteries must be properly disposed of and recycled in compliance
with local regulations. For detailed information, contact your local authority.
•Follow the battery manufacturer’s safety, usage, and disposal instructions.
DISPOSAL
•Coopers of Stortford use recyclable or recycled packaging where possible.
•Please dispose of all packaging, paper, cartons, packaging in accordance with your local
recycling regulations.
•Plastics, polybags –this is made from the following recyclable plastic.

150cm Light Up Acorn Garland H586 Instructions for Use
Please read and retain these instructions for future reference v001: 15/02/21
Code & Symbol
Type of Plastic
Polypropylene
Polystyrene
ABS
Commonly used
for
Microwaveable food
containers, yoghurt pots,
butter tubs, disposable
plates and cups
Insulation boxes,
water cups,
protective packaging
inserts, take away
containers
CD’s, crisp packets,
various flexible
packaging, baby bottles,
sunglass lenses
Notes
Commonly recycled and
collected from household
recycling bins (packaging
tape itself not recyclable but
does not interfere with
cardboard)
Not commonly
recycled but waste
management
centres will recycle it.
Not often or widely
recycled
•At the end of the product’s lifespan please check with your local council authorised household waste
recycling centre for disposal.