GallatinAIR KleanseAIR TRIO User manual
KleanseAIR TRIO
December 2021 KleanseAIR TRIO Product Manual Page 1
Read and save all notices, warnings and safety instructions
received with equipment.
Injury to Persons Hazard
If using the unit in a containment work area, turn off all sources of power to open combustion appliances such as
fireplaces, boilers, furnaces, water heaters, and HVAC systems to avoid the risk of back drafting deadly carbon monoxide
fumes from those appliances. Do not sit or ride on the unit. Do not set any liquids on the top of the unit or store items
on top the unit.
Tipping Hazard
It is not recommended to stack units on top of eachother. When stacking units for storage or
transportation in the original packaging, beware of tipping. Falling equipment could cause bodily harm.
Contamination Hazard
If the unit is used in hazardous or potentially hazardous environments such as mold mitigation job sites:
Wear NIOSH-approved protective gear when changing the HEPA filter as it may contain mold spores and contaminates.
Change the KleanseAIR Pre-Filter and HEPA filter after every remediation job. Dispose of used HEPA according to your
local regulations.
Always disconnect power to the equipment and unplug before performing any service or
maintenance.
Do not operate without proper electrical ground.
On equipment with blowers keep inlet and outlet vents, clean and clear of objects.
Germicidal ultraviolet rays may break down plastic, rubber, or other non-metallic materials,
can fade colors, and can be damaging to plant life. Shield all plastic, rubber, or other non-
metallic parts, plant life, etc. which may be exposed to direct or reflected germicidal ultraviolet rays.
Do not operate equipment if the power cord and/or plug are damaged, or if any other damage to the unit is visible or
suspected. Do not exceed equipment’s maximum rated flow capacity and/or operating pressure.
KleanseAIR TRIO
December 2021 KleanseAIR TRIO Product Manual Page 2
HOW IT WORKS
The KleanseAIR™ TRIO is your solution to improving your personal indoor air quality by removing
particulates, microorganisms, and allergens, all at once through a 3-stage process. Stage l consists of a pre-
filter that is used to maximize the life of the primary HEPA filter. Stage 2 uses a HEPA filter to capture
harmful dust, allergens, pet dander, microorganisms, and other particulates larger than .3 microns. Stage 3
uses UVC lights that shine on the HEPA filter to destroy the collected microorganisms effectively (e.g.,
bacteria, viruses, mold spores) that are captured in Stage 2 at the high efficiency of kill.
The KleanseAIR™ utilizes multistage treatment and filtration enhanced to remove airborne particles such as
dust and miscellaneous debris, and destroying microorganisms caught in the filter. The small size of the
KleanseAIR™ allows it to be portable and easily maneuverable.
Stage 1: 14” x 14” x 1” MERV 8 Pre-Filter
This filter is used to clean the air of larger
particles to keep the primary HEPA filter clean.
These are standard filters that can be purchased
on-line or a local hardware store.
Stage 2: HEPA or ULPA Micron Media Filter
This 4" deep filter removes particles at 0.3 or 0.1
microns and larger such as atmospheric dust,
mites, pollen, mold, spores, fungi, bacteria,
viruses, pet dander, smoke, and more. The ULPA
media filter traps smaller particles than a typical
HEPA filter (0.3 microns). We recommend
changing this filter 12-24 months or as needed.
This filter is custom made by GallatinAIR, and you
will need to contact us for replacements.
Stage 3 – Optional Needlepoint Bi-Polarization Unit
This latest technology creates millions of positive and negative ions deployed in government
buildings, educational institutions, and medical offices. Also, ion bonding to particles
increases their size to be more easily captured by the unit's extra deep HEPA filter. This unit
has a 7-10 year life expectancy.
Stage 4 – Germicidal UVC Lamps
Two 253.7 nm wavelength lamps are enclosed in a chamber to reflect UVC to kill bacteria,
viruses, mold, fungi, and allergens. These lights have a life expectancy of 9,000 hours and can
be purchased by contacting GallatinAIR directly.
KleanseAIR TRIO
December 2021 KleanseAIR TRIO Product Manual Page 3
RECOMMEND SETUP
Set up the air system in an area where it will provide good air circulation but won't get in the way.
To help circulate air, you may want to set up one or more fans somewhat distant from the KleanseAIR™
unit(s). Have the fan(s) blow the air towards the air unit(s). This will help exchange the air so that it quickly
gets processed through the system.
Leaving a system running 24/7 will help clear the air faster.
Since the unit is relatively quiet, it can be run on medium or high setting without disturbing normal
activities.
Do not place the air unit directly against a wall, as you want to ensure airflow.
Please do not use it with an ozone-producing machine.
CONTROL PANEL
GREEN HEPA Air Filter Indicator Light:This indicator will light up green when you turn the fan on.
GREEN UVC#1 and #2 Indicator Lights and UVC light ON/OFF Switch: When the on/off switch is turned on,
the UVC #1 and #2 indicator lights will turn on. If either light goes out, this indicates that a UVC light bulb
has burned out and needs to be replaced. When this happens, contact GallatinAIR for a replacement.
KleanseAIR TRIO
December 2021 KleanseAIR TRIO Product Manual Page 4
SETTING FAN SPEED
Airflow from the KleanseAIR™ is controlled with a variable speed controller. This allows you to set the
airflow at any speed you desire. The following provides you an estimated airflow at each position.
Off Position
In this position, the power to the fan is turned off.
High Position
This is the maximum fan speed.
Medium Position
This is the medium fan speed.
Low Position
This is the medium fan speed
KleanseAIR TRIO
December 2021 KleanseAIR TRIO Product Manual Page 5
UVC OZONE SAFETY
To create ozone from UV, the light wavelength would need to be in the range from 160-240 nm.
Since the KleanseAIR uses UVC with a wavelength of 254 nm, it is outside the ozone-producing range.
The UVC lights in your unit are low-pressure lamps, more like a fluorescent lamp, with a specific
wavelength of 253.7 nm (7782.5 THz).
You can run the system without the lights being on, but you will not get the benefits of the UVC lights.
TROUBLESHOOTING
ISSUE ACTION
Odor/pollutant is not eliminated
Remove source(s) from the area.
Remove contaminated item(s) from the area.
Locate source and treat with Odor Eliminator.
Rep lace HEPA filter.
Adjust the airspeed of the unit.
Odor returns after a few days
The site may have become re-contaminated,
take steps to prevent recontamination and
repeat the process above
Treat source odor with Odor Eliminator
Portable Air System will not turn on
Make sure the Mobile Air System is plugged in
Make sure the back panel is in place.
Check power at the outlet.
Test the on/off switch.
The fan is not turning
Check for obstruction(s).
CONTACTING US
To contact us with questions of any kind, please call us at 855-250-2400 or email us at [email protected]
KleanseAIR TRIO
December 2021 KleanseAIR TRIO Product Manual Page 6
REPLACING FILTERS AND BULBS
•MAIN HEPA FILTER: These filters are designed explicitly for GallatinAIR KleanseAIR units to
maximize the effectiveness of the air filtration process. We advise replacing the filter every 12-24
months depending on the air you are filtering.
•PRE-FILTER (14" x 14" x 1"): We recommend purchasing a MERV 8 filter from an on-line provider
such as Amazon as they are relatively inexpensive. You can also buy these filters at most local
hardware stores.
•UVC LIGHTS:The G23 9v UVC lights we initially provided are of the best quality and made by Philips
Lighting. They are rated to last 9,000 hours (one year). We recommend using the same brand,
make, and model of UVC light.
When you need a new filter(s), please contact your authorized reseller.
AUTO REFILL PROGRAM: For those who are busy and don't want to worry about ordering new filters
on time, GallatinAIR offers an automatic refill program. The yearly refill contains one (1) HEPA FILTER,
(2) PRE-FILTERS, and (2) UVC LIGHTS. The annual plan costs $180 per unit. If you would like to sign up
for yearly, please contact us at 833-250-2400.
KleanseAIR TRIO
December 2021 KleanseAIR TRIO Product Manual Page 7
Lifetime Limited WARRANTY
At GallatinAIR, we stand behind our products with a
lifetime limited on the enclosure and a 1-Year warranty on
major electrical components.
Enclosure: Should you experience any defects in materials
or workmanship with the enclosure over the unit's lifetime,
we will repair or replace the unit for free.
Main Centrifugal Fan: If, within 12 months from the date of
purchase, the primary fan fails, GallatinAIR will repair or
replace the defective fan.
All other electrical components: If within 12 months from
date of purchase, any other electrical part fails (e.g.,
indicator lights, ballasts), GallatinAIR will repair or replace
the unit for free.
The above is subject to the following conditions:
•Any claim made under this warranty must include a
copy of a valid proof of purchase showing the date and
place of purchase.
•Our obligation under this warranty is to the original
purchaser only and may not be transferred.
•Product replacement does not include shipping costs
or labor installation costs.
•GallatinAIR reserves the right to examine the product
in question and its installation environment before
replacement.
•If an identical replacement product is not available,
GallatinAIR reserves the right to replace the defective
product with a similar product.
This warranty relates to defects in manufacture, materials,
or workmanship in a GallatinAIR KleanseAIR product
supplied for use into commercial premises in the United
States. It does not extend to:
•Damage resulting from failure to maintain the product
in accordance with the Care and Maintenance
instructions provided with the product.
•Normal wear and tear, scratches, or accidental damage
•Faults arising from improper use and/or installation.
All incidental or consequential damages are expressly
excluded. No additional warranties, express or implied, are
given, including but not limited to, any implied warranty of
merchantability or fitness for a particular purpose.
When requesting warranty service, you will need to
provide:
•an approved Return Merchandise Authorization
number (RMA) issued by Customer Service
•a dated, valid proof of purchase (payment receipt from
an authorized GallatinAIR reseller)
•a description of the problem
Shipping Your Unit to GallatinAIR: Items must be safely and
adequately packed in such a manner to prevent damage to
the part or product during shipment. For your safety,
please ship via an insured carrier, which employs package
tracking. GallatinAIR will provide a shipping label to the
customer along with an RMA number.
Shipping Unit from GallatinAIR: After the warranty service
is completed, any repaired or replacement parts/products
will be return-shipped via Standard Ground Service paid for
by the customer. Upgraded expedited shipment is available
for a fee.
GallatinAIR will not service received items when:
1. The item is inspected and found to be not covered by the
warranty.
2. The item is inspected and found to be damaged during
shipment due to lack of proper packaging.
Return shipment of such products will be at the expense of
the customer.
For products that are discontinued and no longer
serviceable and/or replaceable, a pro-rated credit towards
a purchase of another similar GallatinAIR brand product will
be issued.
For Warranty Services, please contact for instructions:
GallatinAIR, LLC. 1-855-250-2400
www.gallatinair.com
KleanseAIR TRIO
December 2021 KleanseAIR TRIO Product Manual Page 8
If you purchased the product from one of our Authorized Resellers, please
contact that reseller directly regarding the warranty item.
If you purchased the product directly from GallatinAIR, LLC., please
complete the following steps:
Contact GallatinAIR, LLC. by phone:
For Warranty Services, please contact for instructions:
GallatinAIR, LLC. 1-855-250-2400
www.gallatinair.com
Table of contents
