Garage Smart AGS001 User manual

INSTALLATION GUIDE
Smart Garage
AGS001

WARNING
TO PREVENT SERIOUS INJURY FROM YOUR MOVING GARAGE
DOOR OR GATES:
ü DO NOT let children use Smart Garage Door Opener product and app
without adult supervision.
ü ONLY operate your Smart Garage Door Opener device when you are in
clear view of your garage or gate, and you have verified that there are
no objects are obstructing the operation of the door.
ü ALWAYS wait for garage door or gate to be completely closed.
WHAT’S IN THE BOX
Smart Garage Controller
3M Sticker
Wire Holders
Zip Ties
Sensor Mounting Bracket
Screws / Blots / Nuts

COMPATIBILITY CHECK
Verify the Smart Garage Door Controller works with your garage
door
1. Look for your garage door on the included “Garage Door Compatibility
Guide”.
Ø Garage door openers with yellow / purple learn buttons will likely
NOT work.
2. Manually ensure your garage door opener is compatible with the
Smart Garage Door Controller.
Ø Follow the wires from the wall mounted garage controller to your
garage door opener.
Ø Where the wall mounted garage door controller wires connect to
the opener, use a needle nose plier or paperclip to touch the two
garage door terminals together.
l If the garage door opens or closes, the Smart Garage Door Controller
is compatible with your garage door opener; these will be the
terminals the Smart Garage Door Controller will plug into.

INSTALLATION
1. Check your Wi-Fi
Ø Check the Wi-Fi signal in the garage, where the Smart Garage
Controller will be mounted 4 to 5 feet away from the garage door
opener.
2. Power up your device
Ø Find a convenient location and power the Smart Garage Controller
by plugging it in. The blue LED will start blinking.
3. Download the APP
Ø Install “Smart Life” app on your mobile phone from Apple app store
or Google Play store.

Add Controller Device in the APP
1. Launch the app and tap the Plus ( +) in the top right corner to add a
door sensor device.
2. 3. 4. Select Add manually, Electrician, then Garage Door Opener.

Add Controller Device in the APP
5. Choose your Wi-Fi network and Enter the password. Then tap Next.
6. IMPORTANT !!! Press and hold the ON/OFF button on the Controller
Device until the light is SLOWLY blinking (2s/time).
Ø Tap the “EZ Mode” on the top right corner, change to “AP Mode”.
Ø Select “Confirm indicator slowly blink” at the bottom，tap Next.

Add Controller Device in the APP
7. Tab Go to Connect.
8. Select WLAN on your mobile phone setting.

Add Controller Device in the APP
9. Choose SmartLife-XXXX network on the WLAN setting.
10. Switch back to Smart Life app when WLAN is successfully connected
to SmartLife-XXXX network.

Add Controller Device in the APP
11. It will show Adding device on the Smart Life App.
12. Now your Controller Device is successfully added. Tab Done.

Install the Controller Device to the garage
opener
1. STEP 1 : Connect Controller to Opener
Ø Locate the 2 exposed wires coming out of the Controller.
Ø Insert the 2 exposed wires into the terminals on the back of your
Garage Door Opener.
2. STEP 2 : Install the Sensor
Ø The sensor has 2 parts. Both sensor parts must be mounted parallel to
each other, and they must be 3 – 15 mm apart, not touching.
Ø Mount the sensor with wire on the garage frame wall, and mount
the sensor without wire on the top of garage door.

Installation Overview