GARAGEFLEX FX1301 User manual

If you have any questions or need some advice, please do call us on 01491 579975 or email us at
[email protected] and we will do our best to help.
FX1301 Folding Table with Resin Assembly
Instructions
Package Contents:
1 x Top Bracket
1 x Bottom Bracket
2 x Folding Arm Assemblies
8 x Nuts, washers, yellow caps
1 x Table Top 61x61cm
2 x Stiffeners
8 x Screws
Tools Required:
Phillips screwdriver
Pliers

If you have any questions or need some advice, please do call us on 01491 579975 or email us at
[email protected] and we will do our best to help.
Step 1: Check contents of package and make sure you have everything you need
Step 2: Place the top bracket (A) at the desired distance from the floor. Mount the two folding
arm assemblies (C) on the top bracket and fasten with the supplied nuts, washers and yellow end
caps as shown. Hand tighten the nuts.
Step 3: Mount the bottom bracket on the FlexiPanel (B) and fasten with the supplied nuts,
washers and yellow caps. Wrench tighten the top nuts.
Step 4: Place the 2 stiffeners on the underside of the table top as shown above.

If you have any questions or need some advice, please do call us on 01491 579975 or email us at
[email protected] and we will do our best to help.
Step 5: Fasten the stiffener ends with the supplied screws as shown in 4 places. The top of the
stiffeners should be flush with the ribs at each end.
Step 6: Place the table top back edge in line with the folding bracket assembly.
Step 7: With the supplied 1” screw, fasten through the rear 2 holes on each bracket into the
stiffener previously installed on the table top.

If you have any questions or need some advice, please do call us on 01491 579975 or email us at
[email protected] and we will do our best to help.
Folding Table Operation