Garden Oasis 50-34335A-3673 User manual

See our extensive assortment of outdoor living products
on-line at www.sears.com and www.kmart.com
OWNER’S
MANUAL
Oxford
Cushioned Bench
Date of purchase: _____/ _____/ _____
Caution: Carefully Read Instructions and
Procedures for Safe Operation
Product Code: D71 M80152
KSN: 82997416-1
UPC code: 050874 290625
Made in / Hech en CHINA
Distributed by Sears, Roebuck and Co., Hoffman Estates, IL 60179
sears.com
For questions or comments about product:
Email: www.agio-usa.com or Call toll-free: 1-800-416-3511
Please refer to part numbers when reordering

5 2
Step 4: Tighten all bolts using the hex bolt driver and hex wrench provided. Tighten each bolt a few
revolutions at a time, alternating between bolt connections until all bolts are tihht. Do not
over tighten. Over tightening may strip bolts or damge the weldsthe welds or frame.
Step 5: With the help of another person, Your sofa is now ready for use. If you have any questions,
please call our Customer Service Center at 1-800-416-3511.
IMPORTANT NOTE: Damage to welds or frames resulting from over tightened bolts or imporper
assembly is not covered under our warranty. Please read all instructions carefully before assembly.
I
f you have any questions regarding your assembly, call our Customer Service Center at 1-800-416-3511.

4
IMPORTANT!! PLEASE READ ENTIRE
INSTRUCTION SHEET BEFORE ASSEMBLY!!
TO EXPEDITE ANY FUTURE WARRANTY CLAIMS, PLEASE
KEEP INSTRUCTION SHEET, WARRANTY CARD AND RECEIPT
3
Step 1: Identify all parts packed in the carton against the parts list. Removw all protective materials.
If any parts are missing or damaged, call our Customer Service Center at 1-800-416-3511.
Do not attempt assembly if any parts are missing or damaged.
ASSEMBLY NOTE: The “Left” and “Right” legs are determined facing the sofa, not sitting
in the sofa.
Step 2:
With the help of another person, turn the seat frame in the upright position. Attach back frame
to seat using 5/16“x35 mm bolts and washers as shown in Fig. 1. Guide bolts through holes
in the seat frame, intopre-drilled holes in the back fram. Hand tighten only.
Step 3: Carefully note assembly procedure for chair right leg. Assembly of chair rightleg to seat and
back frame requires use of a 5/16” x 20mm bolts and 1/4” x 25mm bolts and 1/4” x 35 mm
bolts and (thre total). First, position right leg in seat frae, using a 1/4” x 25mm bolt and
1/4” x 35 mm bolt asshown in Fig. 2A. Add a washer to the end of the 1/4” x 25 mm bolt.
Guide these bolts through holes in right leg, into pre-drilled hole in the seat frame. Hand
tighten only. Finally position right leg in back frame, using a 5/16” x 20 mm bolts (H) and
washer as shown in Fig. 2B. Guide bolt through hole in seat frame, into pre-drilled hole in
the right leg. Hand tighten only. Repeat entire procedure (Fig. 2A & Fig. 2B) for left leg.