Garden Oasis HIGHLAND 10X12 GAZEBO User manual

KSN: 0-03888686-7
UPC code: 749241312052
MANUAL
Date of purchase: _____/ _____/ _____
HIGHLAND 10X12 GAZEBO
1
ITEM: 11776
OWNER＇S

HIGHLAND 10X12 GAZEBO
ASSEMBLY INSTRUCTION
Tips:
Warning:
Keep All Flame And Heat Sources Away From This Tent Fabric.
This Tent Is Made With Fabric That Meets CPAI-84 Specifications For Flame Resistance.
It Is Not Fire Proof. The Fabric Will Burn If Left In Continuous Contact With Any Flame Source.
Caution: Gazebo should not be used during inclement weather or high winds.
Do not leave outside during high winds, heavy rains or snow. Remove canopy.
Safety information:
Please read and understand this entire manual before attempting to assemble, operate or
install the product.
Two people are needed for assembly.
2
Warranty: 1 year. This warranty is your sole remedy and applied for the product defects only,
shall be for the original purchaser who should offer the original sales receipt for record.
Questions, problems, missing parts? Before returning to your retailer, call our customer
service department at 1-800-961-9838, 9 AM ~ 5 PM, Pacific Time Zone, Monday – Friday.
Or email us: customer [email protected].

3
Preparation:
Before beginning assembly, make sure all parts are present. Compare parts with package contents
list and hardware contents list. If any part is missing or damaged, do not attempt
to assemble the product.
Estimated Assembly Time: Approx. 2 hours
Tools required for Assembly (not included): Ladder （5ft).
1
2
3
4
5
6
7
8
9
10
11

12
13
14
15
16
17
18
19
20
21
22
23
4

5
Step 1
A. Insert Base Cap (#3) into post (#1). Then fit base flange (#2) underneath post (#1).
B. Insert screw 1 (#13) through post (#1) and secure the base flange (#2). Slide down base
cap (#3) in to place as shown.
C. Repeat step A & B for balance posts.

6
Step 2
A. Insert crossbar B (#5) into crossbar A (#4), connect crossbar B (#5) and crossbar A (#4) by
using screw 1 (#13).
B. Repeat step A for balance 1 crossbar.

7
Step 3
A. Insert crossbar D (#7) into crossbar C (#6), connect crossbar D (#7) and crossbar C (#6) by
using screw 1 (#13).
B. Repeat step A for balance 1 crossbar.

8
Step 4
Place the crossbar sets from steps 2 and 3 as depicted in the illustration below.

9
Step 5
A. Place post (#1) as depicted in the illustration below.
B. Insert screws 2 (#14) through posts (#1). Secure the set onto crossbars B & C (#5 & #6)
as figure below.
C. Insertc screws 2 (#14) through posts (#1). Secure the set onto crossbars A & D (#4 & #7)
as figure below.

10
Step 6
A. Insert 2-Tier roof tubes (#8) into roof connector (#12).
B. Insert corner roof tubes (#9) into 2-Tier roof tubes (#9).
C. Then, secure corner roof tubes (#9) onto posts (#1) by using screws 3 (#15) and nuts (#16)
as figure below.