Gastroversum FKG 261 User manual

Please read these instructions carefully before putting the appliance
into service. They are brief and contain only information which will help
you to obtain the best performance from the appliance.
Take care of all accessories supplied with the appliance.
Bottle capacity is dependant on shelf configuration and bottle sizes.
MODEL:
FKG 261 / 311 / 371
VKG 511 / 571
BOTTLE COOLER / WINE COOLER
INSTRUCTIONS FOR USE

2
CONTENTS
1. Before starting the appliance.
2. How to use the appliance.
3. Maintenance.
4. Has the appliance stopped working?
5. Safety.
6. Technical data.
7. Installation.
8. Change of hinge side.
9. Lighting fixture.
1. BEFORE STARTING
THE APPLIANCE
Check that the cabinet is undamaged.Please
report any damage immediately to your
dealer.Wash the cabinet and inner lining with
a mild unscented detergent and wipe it dry.
Do not use abrasive scouring powder, steel
wool or similar. Connection to the electricity
supply: See head 7 and 8.
2. HOW TO USE THE APPLIANCE
Operating panel (see fig. (5) page 4.
1. Thermostat knob.
2. Indicator for the connection to the
electricity supply (green).
3. Switch for light.
The thermostat knob is adjustable from 0
(stop) to 7 (coldest). Find the position of the
thermostat which gives you the desired
temperature. Start at position 4.
Defrosting
The evaporator is automatically defrosted.
The defrost water is led to a tray on top of the
compressor where it evaporates.
3. MAINTENANCE
Only use an unscented detergent when clea-
ning the cabinet inside.
You may remove the top panel and wash it
when cleaning the cabinet inside.
Switch off the appliance and pull out the plug
when cleaning the cabinet.
The skirting board can be removed to
facilitate a vaccuum-cleaning of the floor. See
fig. (1) page 5.
To make the cooling system work at its opti-
mum it is necessary from time to time to clean
the wire condenser and the compressor at
the back of the cabinet by means of a brush
or a vaccuum cleaner. Remember to clean
the drain.
IMPORTANT! I
n case of damage to the power cord it must
be replaced by a power cord of corresponding
type, available from the manufacturer or his
service representative.
4. HAS THE APPLIANCE STOPPED
WORKING?
Before calling a repairman, check that
lThe plug is properly plugged into the wall
socket.
lThe fuse is intact.
lThe power has not been cut off.
lAll controls are correctly set.
lSwitch off the cabinet for 15 minutes (for
instance at the thermostat). Switch it on
again and after 5 minutes check whether
frost has formed on the evaporator.
lDo not open the cabinet when
unnecessary.
5. SAFETY
Do not store explosive substances in the
refrigerator section, such as gas, cigarette
lighters, petrol, ether or similar. Scrapped
cabinets may become dangerous to children
at play. Therefore, remove the doors or place
the scrapped cabinet in such a way that
children cannot enter it.
Never store liquids with carbon dioxide in the
freezing section.
6. TECHNICAL DATA
This appliance meets the provisions of the
following directives: 89/336/EEC (electro-
magnetic compatibility), 73/23/EEC (electri-
cal equipment designed for use within certain
voltage limits) as amended.
The rating plate, which is placed inside the
appliance (see fig. (6) page 4), provides
various technical information as well as type
and serial number.

3
7. INSTALLATION
See drawings - fig. 1 page (5) - fig. (1), (2)
and (3) page 6.
Install the cabinet in a dry place and so that
it is not exposed to direct sunlight or any other
source of heat.
Place the cabinet in a level position. This is
easily achieved by adjusting the adjustable
feet at the front edge of the base.The cabinet
may not rest against a wall on its hinged side.
When placing the cabinet on a carpet or on
a wooden floor you should adjust it once
more after some time as the cabinet might
settle in soft foundations.
If you want to build the appliance into a cup-
board you must consider 3 factors:
1. There must be space above the
appliance in order to make the cooling
system work satisfactorily. - Fig. (1) page
6.
2. When the door is opened the appliance
takes up more room in the width and
therefore the door must either be placed
outside the cupboard or there must be
a space of at least 15 mm at the hinge
side. - Fig. (2B) page 6.
3. The distance to the wall at the hinge
side must be of a sufficient size. - Fig.
(2B) page 6.
In addition, the bottle cooler may be built in
or positioned alongside another unit – fig.
(3) page 6.
If the wine cooler is to be placed next to
another unit, a 25 mm gap must be left.
Any local installation rules for appliances of
this kind must be observed.
During a storm the electricity supply might
be cut off.
You should be aware of this when installing
the appliance in weekend cottages or
elsewhere where you would not immediately
observe that the power has been cut off.
Construction and details in the accessories
are subject to alteration without previous
notice.
8. CHANGE OF HINGE SIDE
Follow the instructions below if you wish to
install the door hinges at the opposite side.
See the drawings on page 7.
Dismantle the top panel cover - (1) and (2).
Dismantle the top hinge. To be used later as
bottom hinge at the opposite side - (3).
Dismantle the door and its bushing.
Dismantle the bottom hinge - (6).
Place the tension disk and the counter nut
for the hinge pivot on the new bottom hinge.
Mount the door anew.
Tighten the counter nut at the bottom.
Tighten up all nuts.
Mount anew top panel cover and skirting
board cover.
9. LIGHTING FIXTURE
See the drawing on page 7.
1. Pull the screen to the left.
2. Pull down the right side of the screen
and take it out.
- Remove the strip - possibly with text - by
pulling it out of the tracks along the whole
length of the profile.
- The fluorescent tube can be replaced.
The mounting is performed in reverse order.
The glow switch can be replaced without
removing the screen.
DISPOSAL OF THE
APPLIANCE
The appliance contains recyclable
materials. When disposing of the
appliance, please contact the technical
administration or other appropriate
authority in your municipality. They can
inform you of the collection and recycling
measures used in the municipality.

4
Fig. 6
Fig. 4
Mounting of lock for one-door uprights.
Aptional extras.
Fig. 5

5
Fig. 1
Ì
Ì
ÌÌ
Ì

6
min. 25 mm
Fig. 2A
Fig. 2B Fig. 3
1501250/1550/1850
min. 1400/1700/2000
min. 1040
600
min. 15
25

7
CHANGE OF HINGE SIDE
12
3
6
7