Gatekeeper Systems NITRO 401 User manual

401/404
VCR Retrofit to N401
Protecting
Your
Precious Cargo
©
Gatekeeper Systems Inc
Specifications subject to change without notice.
PDN110
Jun 9
, 010
V
.0
#301 31127 WHEEL AVENUE
ABBOTSFORD. B.C. V2T 6H1
TOLL FREE: 1.888.666.4833
TEL: [phone]
FAX: [phone]
g tekeeper-systems.com
Inst ll tion Guide
Refer to below pictorial instructions for setting up proper connections to retrofit your current Gatekeeper VCR to
NiTRO
TM
401 recorders wit or wit out GPS Module :
To “
Cam 1
”
Connector
on N401
To “
Power
”
connector
on N401
To
“Sensors”
connector
on N401
To “
GPS
”
connector
on N401
CAB000215
(Power Sensor/GPS to DB25)
Existing VCR Power
Harness DB25
Connector
To “
Cam
era Harness”
CAB000212
(Composite Video Adaptor-1 C annel)
CAB000214
(Power Sensor to DB25)
To “Power” connector on N401
To “Sensors” connector on N401
GSWHC2-XX
(existing Camera Harness)
Rear View of NiTRO
TM
401

401/404
VCR Retrofit to N401
Protecting
Your
Precious Cargo
©
Gatekeeper Systems Inc
Specifications subject to change without notice.
PDN110
Jun 9
, 010
V
.0
#301 31127 WHEEL AVENUE
ABBOTSFORD. B.C. V2T 6H1
TOLL FREE: 1.888.666.4833
TEL: [phone]
FAX: [phone]
g tekeeper-systems.com
Inst ll tion Guide
a) Disconnect t e VCR power cable (16 AWG w ite wire & black wire) from t e battery. Cut t e cable to remove t e VRS
TM
Box Assembly from t e VCR power cable. Insert a piece of 2.5 inc es lengt 1/4” eat s rink to one end of t e cable. Strip 1/4”
(6mm) of t e wire insulation from t e end of eac wire. Reconnect t e “Live” wires (w ite) and t e “Ground” wires (black) by crimping
t e Butt Connectors (not provided) wit proper crimping tool. Protect t e connections by eating up t e eat s rink.
b) Connect t e provided 2 Ampere Fuse Assembly to t e “Live” wire of t e VCR power cable. T en reconnect t e power cable to t e
battery.
(B) On existing Gatekeeper VCR power arness, proceed wit t e following instructions :