Gateway Solo 1200 User manual

www.gateway.com
Installing a new Solo 1200 hard drive
This package includes a new hard drive for your Solo 1200 notebook computer
and these printed instructions.
Tools you need
You will need a small Phillips screwdriver to install the hard drive.
Preventing static electricity discharge
The components inside your computer are extremely sensitive to static
electricity, also known as electrostatic discharge (ESD).
Before installing the hard drive, follow these guidelines:
■Turn off the computer power.
■Wear a grounding wrist strap (available at most electronics stores) and
attach it to a bare metal part of the computer.
■Touch a bare metal surface on the back of the computer.
■Unplug the power cord and modem cable.
■Remove the battery.
Caution ESD can permanently damage electrostatic discharge
sensitive components in the computer. Prevent ESD
damage by following ESD guidelines every time you
access internal components.
Warning To avoid exposure to dangerous electrical voltages and
moving parts, turn off your computer and unplug the power
cord and modem cable before opening the case.
Warning To prevent risk of electric shock, do not insert any object
into the vent holes of the notebook.

2www.gateway.com
Before working with computer components, follow these guidelines:
■Avoid static-causing surfaces such as carpeted floors, plastic, and packing
foam.
■Remove components from their antistatic bags only when you are ready
to use them. Do not lay components on the outside of antistatic bags
because only the inside of the bags provide electrostatic protection.
■Always hold memory modules by their edges. Avoid touching the edge
connectors and components on the modules. Never slide memory
modules or other components over any surface.
To install the new hard drive:
1Follow the instructions under “Preventing static electricity discharge” on
page 1.
2Shut down the notebook, then disconnect the AC adapter and modem
cables.
3Turn the notebook over, then remove the main battery. For more
information, see your user’s guide.
Warning Disconnect the power cord, remove the battery, and
disconnect the modem cable before you remove the hard
drive. Replace the hard drive before you restore power or
reconnect the modem cable.

3
Installing a new Solo 1200 hard drive
www.gateway.com
4Remove the screw that secures the hard drive kit to the notebook.
5Slide the hard drive kit out until the connector pins disengage.

4www.gateway.com
6Lift the hard drive kit out of the hard drive bay.
7Remove the four screws that attach the hard drive to the hard drive cover.
8Remove the hard drive from the cover.

5
Installing a new Solo 1200 hard drive
www.gateway.com
9Place the new hard drive on the cover.
10 Replace the four screws.
11 Lay the new hard drive kit into the notebook’s hard drive bay.
12 Slide the new hard drive kit in until it is firmly seated.
13 Replace the screw to secure the hard drive kit to the notebook.
14 Reinstall the battery and turn the notebook over.
15 Reconnect the AC adapter and modem cables.

6www.gateway.com
MAN SYS US SL1200 HDD UPD R0 8/01