GDP EZ LYNK Auto Agent User manual

GDP
Quick Guides
page 1
Step 6
Open the AutoAgent™ and verify that your vehicle reads ‘Connected’.
How to establish a connection With your vehicle
Step 1
Unplug the AutoAgent™ directly from the OBD-II port.
Step 2
Boot your ECM by placing your key into the ‘Run’position.
Step 4
Verify that a solid blue light is visible on the AutoAgent™ device.
If only a green light is visible, unplug and replug.
Step 3
Plug the AutoAgent™ directly into the OBD-II port.
Step 5
Connect to the EZLYNK_#### network from your mobile device.
How to Change your vehicle details
Step 1
From the Vehicles screen of the app, select your vehicle.
Step 2
Select Vehicle Details and then select Edit.
Step 4
Select an ECU profile that you wish to install to apply the changes.
Changes are not applied automatically and must be programmed.
Step 3
Adjust your details to fit any vehicle modifications or desires.
Step 5
When your installation has finished, verify any changes made to your vehicle.
Use the following steps to adjust and apply vehicle details using the AutoAgent™ app.
Use the following steps to establish a new connection with your AutoAgent™
and ensure vehicle communication.
www.GDPTUNING.com

GDP
Quick Guides
page 2
How to Contact your GDP technician
Step 1
Open the Vehicles tab from the AutoAgent™ app.
Step 2
Select Technicians to view details and discover your tech’s name.
Step 3
If your vehicle is currently lynked with 0 technicians, you’ll need to contact your dealer
for more info.
Technicians should be contacted in regards to vehicle issues, obtaining ECU profiles, or
adjusting profiles. A GDP technician should not be confused with your dealer.
Use these steps to verify the name of your technician.
How to Lynk your vehicle with a GDP technician
Step 6
Contact GDP via email, phone, or in-app messenging to request your profiles.
Step 1
While connected to the internet or using a mobile data service, open the AutoAgent™ app.
Step 2
Select Vehicles from the app menu and select the vehicle you wish to lynk.
Step 4
Enter the email address provided by your technician and tap Next.
If you weren’t provided an email address, contact GDP.
Step 3
Tap the Technicians button and select Lynk.
Step 5
Describe any modifications that have been made to your vehicle and select Done.
If your vehicle or AutoAgent™ has been set up to automatically lynk with a GDPtechnician,
you will be prompted when you first plug in. If not, you’ll need to use the following steps to
manually share your vehicle details.
www.GDPTUNING.com