GE
Profile'" Models
CLEAN
Use to start or reset a cycle.
I
Reset takes a~oroximately
n
A
60
seconds. Durina resef,
sensor models will fbsh the
Washing LED .and non-
sensor models
will
flash the
Start/Reset LED.
LOADICYCLESELECTIONS
This cycle is for most loads
of everyday dishes, glasses,
NORMAL
and cookware with medium
D
soil levels.
Use to remove tough soils
from pots and pans. It will
not remove burned-onfoods.
[T]
PANS
[T]
SCRUBBER
Use for everyday dishes with
light to medium soil levels
where the soils have not
dried on.
Use for delicate washing of
fine dishware and crystal
with light to medium soil
levels.
Use when the majority of the
post rinses to aid drying.
Used to rinse a partial load
before soils are dried on and
readyfor a wash cycle.
GE
Profile PerformanceTMModels
STATUS
SENSING Displayedduring sensing using turbidity sensor
WASHING Displayedduring prewashand mainwash periods
RINSING Displayedduring rinse periods
DRYING Displayed during heated dry only
CLEAN Displayedwhen cycle is complete
Light remainson until door is opened
OPTIONS
This option must be selected priorto the
start of the wash cycle and will add one
additional prewash cycle lasting
15
minutes.
This option will energize the heater in all
rewash fill cycles. If the wash c cle
[as already started,
it
will not take eiect
until the. beginning of.the next fill
c
cle.
This optlon
IS
not
available
on the dnse
and Hold cycle.
HITEMP
RINSE
n
HEATED
[;I
This option will energize the heater in all
pre-rinse and post-r~nsec cles. If the
rlnse cycle has alread darted, it
will
not take effect untll thexeginnlng of the
nextfill cycle.
Turns on the
500
watt heater calrod
during dry. This option extends the
cycle for an additional
30
min.
NOTE:
After a power outa e the heated dry
option will be on. %his option is not
available on the Rinse and Holdcycle.
Pressjng lock twice within
3
secondswill
deact~vateall ke pads except for the
LOCK
pad. The &ck
LED
will
stay on
whether the cycle
IS
runnlng or not.
Postpones the start of the wash cycle.
Each
successive
push turns on the next
delay LED and sets the countdown
timer. Unlockin the door pauses the
delay start count8own.