GE Profile JT915SKSS Manual

R
Listed by
Underwriters
Laboratories
Dimensions and Installation Information
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,
800.626.2000. Dimension and installation information are shown in inches.
Specification Revised 2/06
220233
JT915SK
GE Profile™ 30" Built-In Single Oven
KW Rating
240V 3.6
208V 2.7
Breaker Size
240V 20 Amps
208V 20 Amps
AAllow 1" overlap of oven over top and bottom edges of cutout
BAllow 11/16"-3/4" for overlap of oven over side edges of cutout
Most 30” Wall Cabinets can be used with this unit.
Note: These ovens are not approved for stackable or side-by-side
installations. Cabinets installed adjacent to wall ovens must have an
adhesion spec of at least a 194°F temperature rating.
Electric wall ovens are not approved for installation with a plug
and receptacle. They must be hard wired in accordance with
installation instructions.
Installation Information: Before installing, consult installation instructions
packed with product for current dimensional data.
C
L
(Must Support 275 LBS.)
2 x 4 or
equivalent
runners
Suitable
bracing
to support
runners
21-5/8"
over centerline
of cabinet
Cutout width
28-1/2'' MIN.
28-5/8'' MAX.
29-3/4
28-1/4
30
Recommended
cutout location
32-1/2"
from floor
21
Junction
box
location
Allow minimum of 21'' for clearance
to adjacent corners, drawers, walls, or etc.
Conduit
(48-1/2"
long)
5
27-1/4'' MIN.
27-5/16'' MAX.
Cutout height
A
B
23-1/2'' MIN.
Cutout depth
22'' MIN.

Optional Undercounter Dimensions and Installation Information
Dimension and installation information are shown in inches.
R
Listed by
Underwriters
Laboratories
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,
800.626.2000.
Specification Revised 2/06
220233
JT915SK
GE Profile™ 30" Built-In Single Oven
Note: 36” ribbon cooktops (excluding JP968)
are approved for use over GE 30” single wall
ovens only. 30” ribbon cooktops (excluding
JP938) are approved for use over GE 30” and
GE 27” single wall ovens. Model JP938 can be
installed over 27” wall ovens except stainless
model JK915 and JK912SF. Refer to cooktop
and wall oven installation information packed
with products for current dimensional data.
Note: CleanDesign or Sealed Burner Gas
This installation is to achieve minimum gap
between bottom of countertop and control
panel. For this installation, the bottom trim will
not be flush with a typical 4” toe kick
Note: Cabinets installed adjacent to wall ovens
must have an adhesion spec of at least a 194°F
temperature rating.
Installation Information: Before installing,
consult installation instructions packed with
product for current dimensional data.
Power cord
for cooktop
Junction box
for oven
Junction box in
adjacent cabinet
for cooktop
hook-up
2 (two) 90°elbows &
sufficient pipe to
connect in adjacent
cabinet
Right cabinet side
3/4" Support
Shut-off
valve
Pressure
regulator
1/2" Black
iron pipe
Union
Conduit
(48-1/2" long)
30" built-in
oven
3-1/2" MIN.
Free space
4" To 4-1/2"
3-1/4
22
Side View
With 36" Gas Cooktop With 30" CleanDesign or Sealed Burner Gas Cooktop
5-9/16"
Reference dim.
for MAX. support
height with typical
36" countertop
height
36" Typical
Countertop height
Power cord
Reference
5-9/16
30-7/16
Free space
1-1/2" MIN.
1-1/2" Typical countertop
Side View
22
27-5/16" MAX.
Cutout height
27-1/4" MIN.
Junction box(s) for
oven & radiant
cooktop 22" from
floor
Add suitable
filler to match
adjacent cabinets
when needed
to maintain toe
kick alignment
30" Oven W/ Rad. Cktp.
5
24
25
Gas or electric cooktops may be installed
over this oven. See cooktop installation
instructions for cutout size. See label on
top of oven for approved cooktop models.
Gas (including the pressure regulator) and
electrical connections for gas cooktop must
be located in an adjacent accessible location.
For a 30" gas cooktop, the connections are
more conveniently made to the right.
120 Volt
Outlet
Gas
connection
Junction box
location
240/208V
36'' MIN.
4'' To 4-1/2 '' Toe kick allowable
Match toe kick height
front and two sides
22'' MIN. above
support platform
Top and/or side
fillers may be
necessary if unit
is positioned
between
existing cabinets
28-1/2'' MIN.
28-5/8'' MAX.
3/4'' Support
platform required
23-1/2" MIN.
Cutout depth
Allow 11/16''
overlap over side
edges of cutout
1-1/2"
Countertop
27-1/4'' MIN.
27-5/16'' MAX.
Cutout height

JT915SF
Specification Revised 2/06
220233
Features and Benefits
• Precise AirTM convection system - Delivers even air and heat circulation for
superior baking and roasting results
• Convection bake (multi-rack) - Provides ideal convection baking for multiple
racks of food, ensuring superb results
• Convection roast - Provides even cooking and consistent results, roasting
meats up to 25% faster than a conventional oven
• Glass touch oven controls - Feature a smooth glass design that is both
easy-to-operate and easy-to-clean
• Self-clean oven - Conveniently cleans oven cavity without the need
for scrubbing
• Super-large oven capacity - Provides the impressively large oven interior for
cooking more dishes and large meals at one time
• TrueTempTM system - Delivers even heat distribution and maximum
oven control
• Model JT915SKSS – Stainless steel
JT915SK
GE Profile™ 30" Built-In Single Oven