GE Monogram ZISW360DM User manual

Monogram.
™
For answers to your Monogram,
® GE Profile™or
GE appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center®service, 800.626.2000.
R
Listed by
Underwriters
Laboratories
Specification Revised 2/02
ZISW360DM - GE Monogram 36" Built-In Refrigerator with Dispenser and
Water Filter
35-1/2
7"
5"
Electrical
Area
84 1/2" max
83 1/2" min
Finished
Opening 74" From Floor
to Bottom
of Electrical
24"
5" 5" 3 1/2"
Water Supply
3 1/2"
36" Models 12"
Water And Electrical Locations
The opening must be prepared with the electrical and water
supply located as shown.
The cutout depth must be 24".
Designed for industry standard flush installation. The
refrigerator will project forward, slightly beyond adjacent
cabinetry, depending on your installation.
The cutout depth beneath a soffit:
When installed beneath a soffit, the soffit cannot exceed the
24” installation depth shown. The top case trim overlaps the
bottom of the soffit.
Frameless cabinets:
The case trim overlaps cabinets at the top and sides.
Therefore, frameless cabinets may require filler strips to
prevent interference with cabinet door swing. The opening
must allow for filler strips.
Additional Specifications
•A 115 volt 60Hz., 15 or 20 amp power supply is required. An
individual properly grounded branch circuit or circuit breaker
is recommended. Install a properly grounded 3-prong electrical
receptacle recessed into the back wall. Electrical must be
located on rear wall as shown.
Note: GFI (ground fault interrupter) is not recommended.
•Water line can enter the opening through the floor or back
wall. The water line should be 1/4" O.D. copper tubing between
the cold water line and
water connection location, long enough to extend
to the front of the refrigerator. Installation of an easily
accessible shut off valve in the water line is recommended.
THE INSTALLATION SPACE
Product Clearances
These refrigerators are equipped with a 2 position door
stop. The factory set 130°door swing can be adjusted
to 90°if clearance to adjacent cabinets or walls
is restricted.
15"
13"
23-7/8"
Behind
Frame
20-5/8
Allow minimum clearances for freezer door and
fresh food door for a full 130°door swing and to
allow for pan removal.
4" minimum clearance is required when door
swing is adjusted to 90°. If the 90°door stop
position is used, pan access is maintained, but
pan removal is restricted.
*84" From
Floor to
Top Frame
36"
Frame to Frame
35"
Case Width
*83-1/2"
at
Rear
* Shipping height.
The refrigerator
can be adjusted to
fit into a cutout that
is 83-1/2”min. to
84-1/2”max. height
Note that the top
case trim at the
front is 1/2”higher
and will overlap
upper cabinetry or
soffit. Use leveling
legs and wheels for
height adjustment.
As an ENERGY STAR®Partner,
GE has determined that this product
meets the ENERGY STAR®
guidelines for energy efficiency.

Specification Revised 2/02
Monogram.
™
For answers to your Monogram,
®GE Profile™or
GE appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center®service, 800.626.2000.
R
Listed by
Underwriters
Laboratories
ZISW360DM - GE Monogram 36" Built-In Refrigerator with Dispenser and
Water Filter
1/4" FRAMED PANEL DIMENSIONS
If you choose to install framed panels, they must be cut to
the dimensions shown. The panels will slide into the frame
on the door and grille.
Non-Dispenser Models
If the custom panel is less than 1/4" thick and it fits loosely in
the door frame it can be backed up with
a piece of filler material or foam tape to improve
the fit.
1/4"
Panel
Door
5/16"
Trim
Reveal
IMPORTANT NOTE: Maximum weight for fresh food panel is
50 pounds and 30 pounds for freezer panel.
IMPORTANT NOTE – Dispenser Models
The refrigerator is supplied with two dispenser trims, one for
framed panels and one for overlay panels.
•If the panel is less than 0.250" thick a noticeable gap may be
created around the dispenser trim. Foam tape may be applied
on the door to improve the fit.
•If the panel is more than 0.250" thick, the dispenser trim
cannot be secured to the door.
Fresh Food
Panel
Freezer
Panel
18-9/16
14-9/16
17-13/16
3-1/8
33-7/8
9
Grille Panel
68-3/8
Dispenser
Cutout
9-5/8"
Dispenser Cutout
15-3/8"
The framed panel must be 1/4"
nominal thickness to fit the
dispenser trim.
SIDE PANELS
Side panels must be used
whenever the sides of the
refrigerator will be exposed.
The 1/4" side panels will slip
into the side case trim. Order
the side panels from the
cabinet manufacturer.
* Depending on
installation height.
*84"
2-9/16"
24"
*3" to 4"
As an ENERGY STAR®Partner,
GE has determined that this product
meets the ENERGY STAR®
guidelines for energy efficiency.

Monogram.
™
For answers to your Monogram,
®GE Profile™or
GE appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center®service, 800.626.2000.
R
Listed by
Underwriters
Laboratories
Specification Revised 2/02
3/4" OVERLAY PANEL DIMENSIONS
For a more custom appearance, overlay panels may be installed on
trimmed models. The overlay panel must be secured to a 1/4" thick
backer panel which slides into the trim. A spacer panel 0.10" thick
must be placed between the overlay and backer panel.
Assemble the panels with glue and screws.
•Center the spacer panel on the backer panel, left to right and top to
bottom. Secure the panels with glue.
•Center the spacer and backer panel on the overlay panel and
secure with glue and screws. Screws must be countersunk into the
backer panel.
3/4"
Overlay
Panel
1/4"
Backer
Panel
Door
.10"
Spacer
ZISW360DM - GE Monogram 36" Built-In Refrigerator with Dispenser and
Water Filter
Spacer Panel
Overlay Panel
Backer Panel
.250" + .10" + .750" = 1.100" Total Panel Thickness
NOTE: Left-to-right
offset is not always
equal to top-to-bottom
offset.
IMPORTANT NOTE –Dispenser Models
The refrigerator is supplied with two dispenser trims, one for
framed panels and one for overlay panels. The overlay dispenser
trim is designed to fit a total panel thickness of 1.100".
•If the panel is less than 1.100" a noticeable gap may be created
around the dispenser trim.
•If the panel is more than 1.100" the dispenser trim cannot be
secured to the door.
•The overlay panel must be constructed according to the
specifications shown to achieve the correct total thickness.
•Alternative panel construction methods such as securing a 3/4"
panel to a 1/4" backer panel cannot be used. Another method,
routing a 3/4" thick panel on all sides cannot be used. These
methods will not result in the required 1.100" panel thickness.
Fresh Food
Panel
Freezer
Panel
E
D
F
G
A
B
Grille Panel
C
Dispenser
Cutout
9-5/8"
Dispenser Cutout
15-3/8"
ABCD EF G
1/4”Backer Panel 33-7/8 9 68-3/8 14-9/16 18-9/16
.10”Spacer Panel 33 8-3/8 67 13-1/4 17-1/4
3/4" Overlay Panel 34-1/8 9-1/4 68-5/8 14-13/16 18-13/16 17-15/16 3-1/4
*Dispenser
Cutout Position
*Cut the dispenser opening after the backer, spacer and overlay panels
have been assembled.
IMPORTANT NOTE: Maximum
total weight for assembled fresh
food panel is 50 pounds and 30
pounds for freezer panel.
As an ENERGY STAR®Partner,
GE has determined that this product
meets the ENERGY STAR®
guidelines for energy efficiency.

Monogram.
™
For answers to your Monogram,
®GE Profile™or
GE appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center®service, 800.626.2000.
R
Listed by
Underwriters
Laboratories
Specification Revised 2/02
ZISW360DM - GE Monogram 36" Built-In Refrigerator with Dispenser and
Water Filter
Framed panels
You may install 1/4" thick custom panels from your cabinet
manufacturer. The decorative panel slides into the factory
installed trim. Or, order black, white and stainless steel
accessory panels from your Monogram dealer.
Framed Panel Standard Door Handles
Door Handles
The standard supplied handles can be adjusted to
accommodate both framed or overlay panels. Custom
handles of your choice, supplied by your cabinet maker can
also be installed. If desired, you may order ZKHSS2
Monogram stainless steel tubular handle kit.
Overlay panels
You may also choose to install custom overlay panels from
your cabinet manufacturer. This design provides a seamless
appearance which integrates smoothly with surrounding
cabinetry.
Side Panels
Side panels must be used whenever the sides of the
refrigerator will be exposed.
Optional Accessory Kits
ZKHSS2: Monogram Tubular Stainless Steel handles
designed to fit overlay panels.
Accessory Panels
White, black and stainless steel accessory panels are
available from your Monogram dealer. Panels are cut to size
and ready to install.
Models White Black Stainless
Acrylic Acrylic Steel
ZISW480D ZPW480D ZPS480D
ZISB480D ZPB480D ZPS480D
ZIS480N ZPW480N ZPB480N ZPS480N
ZISW420D ZPW420D ZPS420D
ZISB420D ZPB420D ZPS420D
ZIS420N ZPW420N ZPB420N ZPS420N
ZISW360D ZPW360D ZPS360D
ZISB360D ZPB360D ZPS360D
ZIS360N ZPW360N ZPB360N ZPS360N
Standard Door Handles
3/4" Overlay Panel
.10" Thick Spacer Panel
1/4" Thick Backer Panel
Standard supplied handles shown in 1/4”panel position. Standard supplied handles shown in 3/4”overlay panel position.
As an ENERGY STAR®Partner,
GE has determined that this product
meets the ENERGY STAR®
guidelines for energy efficiency.

Monogram.
™
For answers to your Monogram,
®GE Profile™or
GE appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center®service, 800.626.2000.
R
Listed by
Underwriters
Laboratories
Specification Revised 2/02
DISPENSER MODELS:
RAISED OVERLAY PANEL DESIGN
ZISW360DM - GE Monogram 36" Built-In Refrigerator with Dispenser and
Water Filter
When a raised panel design is to be used, a
custom wide middle rail is required to accept the
dispenser trim.
•The middle rail must be wide enough to allow for
the dispenser trim to overlap the opening.
•The middle rail must be 1.100" total thickness to
accept the dispenser trim.
1/4" Backer Panel
.10" Spacer
3/4" Overlay Panel
Wide
Middle
Rail is
Required
1/4" FRAMED PANEL
•The dispenser trim fits over the custom panel and
snaps into the freezer door.
•The clips will not engage the door if the panel is
more than 0.250" thick.
•If the panel is less than 0.250" thick, a noticeable
gap may be created around the dispenser trim.
3/4" OVERLAY PANEL
•The dispenser trim fits over the custom panel and
snaps into the freezer door.
•The clips will not engage the door if the panel is
more than 1.100" thick.
•If the panel is less than 1.100" thick, a noticeable
gap may be created around the dispenser trim.
Dispenser
Trim
16-3/4"
10-5/8"
DISPENSER TRIM FIT EXAMPLES:
(NOT TO SCALE)
1/4"
Framed
Panel
1/4" Backer Panel
.10" Spacer
Panel
1/4" Dispenser Trim
3/4" Overlay Dispenser Trim
3/4" Overlay
Panel
FREEZER DOOR
FREEZER DOOR
0.250"
Thick
1.100"
Total Thickness
Ice / Water Dispenser
Ice / Water Dispenser
As an ENERGY STAR®Partner,
GE has determined that this product
meets the ENERGY STAR®
guidelines for energy efficiency.

Specification Revised 2/02
Monogram.
™
CONTROL
LOCK
DOOR
ALARM
Features and Benefits
•Energy Star®Qualified
•21.7 cu ft Capacity (Fresh Food 11.9 cu ft /
Freezer 9.8 cu ft)
•Multi-Shelf Halogen Light Tower
•Multi-Shelf Air Management Tower
•Exterior Proximity Sensor Dispenser with Cubes,
Crushed Ice and Chilled Water
•GE SmartWater™Filtration System
•Climate Control Drawer with Express Chill,
Express Thaw and Select Temp
•Sealed Adjustable Humidity, Slide-Out Produce
Pan with Easy Access Lid and Full
Extension Slides
•Sealed High Humidity Produce Pan with Full
Extension Slides
•Adjustable Sealed Deli Pan with Full
Extension Slides
•3 Adjustable, 1 Fixed Spill-Proof Glass Fresh
Food Shelves
•Gallon Door Storage
•4 Adjustable Door Bins
•Sealed Dairy Compartment
•Wine Caddy
•Glass-Covered Butter Dish
•Freezer Multi-Shelf Halogen Light Tower
•4 Adjustable Wire Freezer Shelves
•2 Utility Baskets with Full Extension Slides
•3 Adjustable Freezer Door Bins
•Slide-Out Can Rack
•Automatic Icemaker
•Removable Ice Storage Bin
•Model ZISW360DM–White Dispenser
•Model ZISB360DM–Black Dispenser
ZISW360DM - GE Monogram 36" Built-In Refrigerator with Dispenser and
Water Filter