GE ZISS360NXSS User instructions

OVERALL DIMENSIONS
Product Specification Revised 9/14
ZISS360NXSSGE Monogram®36" Built-In Side-by-Side Refrigerator
36" (91.5)
25 3/4" (65.4)
23 7/8" (60.7)
*84"
(213.4)
*3 1/2"
(8.9)
2"
(5.1)
*72 1/4"
(183.5)
*64 1/4"
(163.2)
*4 1/4"
(10.8)
*83 1/2"
(212.1)
** Allow 13" (33.0) min
clearance for 130˚
door swing
** Allow 15" (38.1) min
clearance for 130˚
door swing
20 5/8"
(52.4)
TOP VIEW
35" (89.0)
Case width
ZISS360NXSS
SIDE VIEWFRONT VIEW
* Shipping height. Use leveling legs and wheels for maximum
1" height adjustment from shipping height.
** Allow 4" (10.2) min
clearance to a wall for 90˚
door swing
** Allow 4" (10.2) min
clearance to a wall for 90˚
door swing
** These refrigerators are equipped with a 2-position door stop. The factory-set 130° door
swing can be adjusted to 90° if clearances to adjacent cabinets or walls is restricted. Allow
full 130° door swings for pan removal. If the 90° door stop position is used, pan access is
maintained, but pan removal is restricted.
ATTENTION ELECTRICIAN:
A 115 volt 60Hz., 15 or 20 amp power supply
is required. An inidividual properly grounded
branch circuit or circuit breaker is recommended.
Install a properly grounded 3-prong electrical
receptacle recessed into the back wall.
SPECIFICATIONS
Overall Width 36" (91.44 cm)
Overall Height 84" (213.36 cm)
Overall Depth 25 3/4" (65.41 cm)
Door Clearance 20 5/8" (52.4 cm)
Cutout Width 35 1/2" (90.2 cm)
Cutout Height 83 1/2" - 84 1/2"
(212.1 - 214.6 cm)
Cutout Depth 24" (61 cm)
Plumbing Requirements 1/4" OD copper
tubing or GE
SmartConnect kit
Shipping Weight 675 lb
Dimensions in parentheses are in centimeters unless otherwise noted.
Actual product dimension may vary due to manufacturing tolerances.
36" (91.5)
25 3/4" (65.4)
23 7/8" (60.7)
*84"
(213.4)
*3 1/2"
(8.9)
2"
(5.1)
*72 1/4"
(183.5)
*64 1/4"
(163.2)
*4 1/4"
(10.8)
*83 1/2"
(212.1)
** Allow 13" (33.0) min
clearance for 130˚
door swing
** Allow 15" (38.1) min
clearance for 130˚
door swing
20 5/8"
(52.4)
TOP VIEW
35" (89.0)
Case width
ZISS360NXSS
SIDE VIEWFRONT VIEW
* Shipping height. Use leveling legs and wheels for maximum
1" height adjustment from shipping height.
** Allow 4" (10.2) min
clearance to a wall for 90˚
door swing
** Allow 4" (10.2) min
clearance to a wall for 90˚
door swing
** These refrigerators are equipped with a 2-position door stop. The factory-set 130° door
swing can be adjusted to 90° if clearances to adjacent cabinets or walls is restricted. Allow
full 130° door swings for pan removal. If the 90° door stop position is used, pan access is
maintained, but pan removal is restricted.

STANDARD INSTALLATION
ANTI-TIP BRACKET
Product Specification Revised 9/14
FRONT VIEW SIDE VIEW
W
24" (61.0)
2"
(5.1)
4"
(10.2)
7/16" (1.1)
Trim overlap
3 1/2"
(8.9)
E
WATER
35 1/2" (90.2)
12" (30.5)
*83 1/2" min
*84 1/2" max
(212.1-214.6)
*Trim will overlap
additional 7/16"
3 1/2"
(8.9)
75"
(190.5 )
From floor
to bottom
of electrical
area
6"
(15.2)
5"
(12.7)
5"
(12.7)
5"
(12.7)
ZISS360NXSS
SIDE VIEW INSTALLED
WITH WOODEN WALL STUDS
AND NO SOFFIT
SIDE VIEW INSTALLED
UNDER SOFFIT
SOFFIT
*84"
(213.4)
*Or installation
height from floor
2" x 4"
Cut to 35" Length
Screws mounted
into vertical wall
studs
FRONT VIEW INSTALLED
WITH METAL WALL STUDS
AND NO SOFFIT
Top Case Trim
3/4"
Min.
Side View Top
Case Trim
Install Screws
Through Trim and Into
3/4" Min. Wood Brace
FRONT VIEW SIDE VIEW
W
24" (61.0)
2"
(5.1)
4"
(10.2)
7/16" (1.1)
Trim overlap
3 1/2"
(8.9)
E
WATER
35 1/2" (90.2)
12" (30.5)
*83 1/2" min
*84 1/2" max
(212.1-214.6)
*Trim will overlap
additional 7/16"
3 1/2"
(8.9)
75"
(190.5 )
From floor
to bottom
of electrical
area
6"
(15.2)
5"
(12.7)
5"
(12.7)
5"
(12.7)
ZISS360NXSS
SIDE VIEW INSTALLED
WITH WOODEN WALL STUDS
AND NO SOFFIT
SIDE VIEW INSTALLED
UNDER SOFFIT
SOFFIT
*84"
(213.4)
*Or installation
height from floor
2" x 4"
Cut to 35" Length
Screws mounted
into vertical wall
studs
FRONT VIEW INSTALLED
WITH METAL WALL STUDS
AND NO SOFFIT
Top Case Trim
3/4"
Min.
Side View Top
Case Trim
Install Screws
Through Trim and Into
3/4" Min. Wood Brace
A
B
D
E
C
ZISS360NXSSGE Monogram®36" Built-In Side-by-Side Refrigerator
The refrigerator will project forward,
slightly beyond adjacent cabinetry.
AMounting the junction
box in this location will
also allow for front
accessability through
access panel.
BWater supply area.
WARNING:
The refrigerator is top
heavy and must be secured
to prevent the possibility of
tipping forward. Failure to
do so may result in death
or serious injury.
The information below is
for cabinet design only.
When installing the anti-
tip system you must use
the product installation
instructions.
Determine your installation
construction and required
anti-tip configuration:
CInstalled Under Soffit
After installing unit into
installation opening,
raise grille panel and
screw metal case sides to
adjacent cabinet. When
installed under a soffit,
the soffit cannot exeed 24”
deep. The top case trim
overlaps the bottom of the
soffit.
DWooden Wall Studs and
No Soffit
• Cut a 2” x 4” block and
secure to brackets
provided.
• Secure brackets to back
wall of opening at 84” or
your installation height
from the floor.
EMetal Wall Studs and
No Soffit
This method requires
securely fastened cabinets
on both sides and a ¾”
minimum wood brace
above unit, with it’s front
surface 24” from back wall.
• After installing unit into
opening, raise grille panel
and attach metal case
top trim to ¾” minimum
wood brace.
• The brace spanning
the enclosure must be
securely fastened to
cabinets on both sides.
See Installation
Instructions for detailed
instructions.
NOTES

NOTES
Product Specification Revised 9/14
ZISS360NXSSGE Monogram®36" Built-In Side-by-Side Refrigerator
FSide panels must be
used whenever the sides
of the refrigerator will
be exposed. The 1/4”
side panels will slip
into the side case trim.
Secure the panels to
the refrigerator with
stick-on hook and loop
fastener strips. Order
the side panels from the
cabinet manufacturer.
CUSTOM SIDE PANELS
F
2 9/16"
(6.5)
*3" - 4"
(7.6 - 10.2)
*Depending
on installation
height
1 7/8"
(4.8)
24" (61.0)
3/16"
(.5)
*84”
(213.4)
*Depending
on installation
*84"
(213.4)
*Depending
on installation
height
ZIF360NXLH_ZIF360NXRH _ZIFP360NXLH_ZIFP360NXRH_ ZIFS360NXLH_ZIFS360NXRH
ZIR360NXLH_ZIR360NXRH_ZIRP360NXLH_ZIRP360NXRH_ZIRS360NXLH_ZIRS360NXRH

FEATURES AND BENEFITS
R
Product Specification Revised 9/14
Halogen Light Columns - Located in the freezer
and fresh food compartments, extend the full
length of the interior compartments providing
brilliant, all-level illumination
LED Lighting - Located at the top of the fresh
food compartment, and inside the vegetable and
climate-control drawers, illuminates contents
without compromising space
Advanced Temperature Management System
with Multi-Shelf Air Tower - Provides even
distribution of air throughout the refrigerator
Climate-Control Drawer - Allows you to express-
chill beverages, express-thaw meats and select
specific temperatures for perishable foods
Filter-Change Indicator Light - Located on the
upfront control panel, provides a visual reminder
when it's time to replace the filter for the water
dispenser
GE®Water Filter - Has been moved from the
fresh food compartment to the overhead cabinet,
where it is discreetly out of sight
Dairy Bin with Center Divider - Has a unique
magnetic seal that locks in freshness
Adjustable Deli Drawer on Full-Extension Slides
- Keeps meats, cheeses and other everyday foods
within easy reach
Drop-Down Shelf - Provides additional space for
a casserole dish or pizza box
ZISS360NXSSGE Monogram®36" Built-In Side-by-Side Refrigerator