Gemmy 47006 User manual

1
SAFETY WARNING: Remove all plastic fasteners and tags. These are part
of the packaging and should be discarded.
SAVE THESE INSTRUCTIONS – This manual contains important
safety and operating instructions for power units.
WARNING
ELECTRIC PRODUCT. Keep away from children. Not recommended for children under
3 years of age. As with all electrical products, precautions should be observed during
handling and use to reduce the risk of electric shock. If the supply cord is damaged, it must
be replaced by the manufacturer, its service agent or similarly qualified persons in order to
avoid a hazard.
WARNING
Strobe lights have been known to trigger seizures in people with photosensitive epilepsy.
WARNING
The light is very bright. Do not shine directly into eyes.
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING(THIS FURNISHING)
WARNING: WHEN USING AN ELECTRICAL FURNISHING BASIC
PRECAUTIONS SHOULD ALWAYS BE FOLLOWED
WARNING: TO REDUCE THE RISK OF BURNS, FIRE, ELECTRIC SHOCK
OR INJURY TO PERSONS :
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
1. Suitable (for mounting) within 4 feet of the ground. Route Cord to prevent tripping; Do not use extension cords
with this product; Protect power supply cord from crushing or stepping; To replace cord, contact place of purchase
or manufacturer;Do not close furnishing (or a part of the furnishing shall be identified) on products plugged into
receptacles or luminaires.; Do not use when wet; do not submerse. Remove power when not in use.
2. Unplug from outlet before putting on or taking off parts.
3. Never operate this furnishing if it has a damaged cord or plug, if it is not working properly, if it has been dropped
or damaged, or dropped into water. Return the furnishing to a service center for examination and repair.
4. Keep the cord away from heated surfaces.
5. Close supervision is necessary when this furnishing is used by, or near children, invalids, or disables persons.
6. Do not secure the wiring of the product with staples or nails, or place on sharp hooks or nails.
7. Do not let lamps rest on the supply cord or on any wire.
8.
Use this furnishing only for its intended use as described in these instructions. Do not use attachments not recommended
by the manufacturer.
9. Do not close doors or windows on the product or extension cords as this may damage the wire insulation.
10. Do not cover the product with cloth, paper or any material not part of the product when in use.
11. Ground Fault Circuit Interrupter (GFCI) protection is to be provided on the circuit(s) or outlet(s) to be used for
the wet location portable luminaire. Receptacles are available having built-in GFCI protection and are able to
be used for this measure of safety.
12. Use only with an extension cord for outdoor use, such as an extension cord of cord type SEW, SEOW, SOW,
SOOW,STW, STOW, STOOW, SJEW, SJEOW, SJEOOW, SJW, SJOW, SJOOW, SJT W, SJTOW, or SJTOOW.
13. To reduce the risk of electric shock, this furnishing has a polarized plug (one blade is wider than the other). This
plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.
INSTRUCTIONS
E

2
14. Do not contact of the cord, or contact of combustibles such as plastic, paper goods, and similar materials, with
the lamp, lampholder and reflector; the luminaire is not intended for illumination of aquariums, the luminaire is
not intended for installation in plastic cabinets.
15. Read and follow all instructions that are on the product or provided with the product.
SAVE THESE INSTRUCTIONS.
FEATURES
- Plastic housing with 3 pieces high power LEDs.
- UL power cord operated.
- Easy installation.
- High quality, long product life.
TECHNICAL SPECIFICATIONS
ASSEMBLY INSTRUCTIONS
1. Gently remove contents from packaging and lay out in a clear area.
2. Secure the stake with handle together. Insert the stake into the ground.
(See illustration 1)
3. Plug power cord into standard wall socket. (See illustration 2)
4. Unplug when not in use.
OPERATING DETERMINATIONS
This product was designed for indoor and outdoor use.
Do not shake the device. Avoid brute force when operating the device.
Keep away from direct insulation (particularly in cars) and heaters.
Do not permit operation by persons not qualified to operating the device. Most damages are the result of
unprofessional operation!
Never use solvents or aggressive detergents in order to clean the device! Rather use a soft and damp cloth.
Please use the original packaging if the device is to be transported.
Unauthorized modifications on the device are unacceptable due to safety reasons!
If this device is operated in any way different from the ways described in this manual, the product may suffer
damages and the guarantee becomes void.
illustration 1
illustration 2
Material: PC
Light sourcing: 1W LED * 3
Rating 120VAC 60Hz

3
OPERATION
- Insert the plug into socket.
- Set this device as a projector.
- Extract the plug if not in use. Be careful with the power cord!
- Route the power supply cord away from walkways, driveways and traffic areas to prevent trip hazards and damage
to the power supply cord,
- Do not place outdoor use furnishings near pools, ponds or other bodies of water.
- CAUTION- unplug this furnishing from the electrical outlet before cleaning.
WARNING
• The device is for indoor and outdoor use!
• Suitable for outdoor use!
•For household / Residential use only!
•This furnishing has not been evaluated for flammability or cigarette ignition resistance!
•Please keep away from heaters and other heating sources!
IMPORTANT
Damages caused by the disregard of this user manual are not subject to warranty. The dealer will not accept
liability for any resulting defects or problems. Keep away from heaters and other heating sources! If the device
has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately.
Leave the device switched off until it has reached room temperature. Please note that damages caused by manual
modifications on the device or unauthorized operation by unqualified persons are not subject to warranty. Keep
young children and amateurs away from the device!
CAUTION
Risk of Fire or Electric Shock. If the cord is not long enough, connect to power tap with built-in overcurrent protection,
or contact manufacturer to replace unit with one having a longer cord.
USE AND CARE INSTRUCTIONS
1. Before using and reusing, inspect the product carefully. Discard any products that have cut, damaged or frayed
wire insulation cords, cracks, lamp holders or enclosures, loose connections, or exposed copper wire.
2. When storing the product, carefully remove the product from wherever it is placed, including trees, branches, or
bushes, to avoid any undue strain or stress on the product conductors, connections and wires.
3. When not in use, store neatly in a cool, dry location protected from sunlight.
WARNING
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:

4
Visit
WWW.GEMMY.COM
for more information.
©2014 GEMMY INDUSTRIES CORP.
117 WRANGLER DRIVE. SUITE 100
COPPELL, TX 75019 U.S.A.
1 (877) 250-9032
MADE IN CHINA
PRINTED IN CHINA
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING
CAN ICES-3(B).
THESE INSTRUCTIONS ARE FOR THESE ITEMS
47006 47007 47008 47454 47037 47038 35546
35547 35549 35863 35864 35954 35956 47570
56353 56356 56368 56372 35074 35589 88579
88610 88619 35072 35592 89629 89733 89734
56721 64863 64864 64865 64866 64867 50940
64868 88092 88093 88105 88106 88107 89250
45940 45942 45944 45999 54178 56351 56366
56721 56777 57267 36468 36469
This manual suits for next models
52
Table of contents
Popular Light Fixture manuals by other brands

Lightmybricks
Lightmybricks LEGO LAMBORGHINI SIAN FKP 37 42115 installation guide

AL Tech
AL Tech ALHS Replacement instructions

HAMPTON BAY
HAMPTON BAY SKU 939-473 instruction manual

Delta Light
Delta Light KIRR SET 15 manual

superbrightleds
superbrightleds LP-NW3030-35-12V user manual

COLORKINETICS
COLORKINETICS Accent Compact iColor installation instructions