Generex SM MD User manual

Version: 2009-03-03
1 Copyright of the European Union is effective (Copyright EU) (c) 2012 GENEREX GmbH, Hamburg, Germany, All rights reserved
TEL [phone] - EMAIL [email protected] - WEB www.generex.de (This and all other product datasheets are available for download.)
SM_MD Motion Detector
The SM_MD is a passive infrared motion detector with a PIR sensor. It reacts on every kind of heat
motion and notifies it to the alarm control unit.
Assembling:
Optimal assembly site is 2 to 3 meters over the ground. The possible direction of motion should be
happen cross to the detector. Improper for the assembling are all sites adverse heat sources (e. g.
radiator) or a window. Do not assemble the motion detector nearby power lines, gas lines or electrical
devices, which will generate heat during long-time operation.
The perspective of the SM_SD is 90 degrees, the reach of detection, depends of the assembling
height, is 15 x 15 meters. You can modify the sensitivity of the motion detector via jumper. So you
assign the amount of impulse, which have to be identified, prior the detector will open the alarm relay.

2 Copyright of the European Union is effective (Copyright EU) (c) 2012 GENEREX GmbH, Hamburg, Germany, All rights reserved
TEL [phone] - EMAIL [email protected] - WEB www.generex.de (This and all other product datasheets are available for download.)
Connection diagramm:
A: Terminal
B: Sabotage
C: PIR-Element
D: LED
E: Impulse counter
F: Jumper-LED
Terminal:
1 and 2: Sabotage
3: Free
4 and 5: Alarms
6 and 7: Voltage Input (GND, 12V)
Configuration:
The SM_MD will be delivered with an adequate cable for the connection to the SensorManager.
Connect the cable into the input of the SensorManager and connect via web-browser on your CS121.
Click the „SensorManager“ configuration button and set the desired data into the „Sensor Manager
Inputs“ menu.
Click the „Events / Alarms“ button into the CS121 configuration menu and add a desired job via the job
editor for the event „SensorMan Input 4 Not Normal“.
Please take a look into the CS121 or rather the SensorManager manual for further information.

3 Copyright of the European Union is effective (Copyright EU) (c) 2012 GENEREX GmbH, Hamburg, Germany, All rights reserved
TEL [phone] - EMAIL [email protected] - WEB www.generex.de (This and all other product datasheets are available for download.)
Technical data:
Operational voltage: 9-16V DC (nom. 12V DC)
Power input: 9mA bei 12V
Alarm contact: NC, 100mA, 24 V DC max.
Sabotage contact: NC, 100mA, 24 V DC max.
Area of detection: 15 x 15 meter
Height of installation: 2m bis 3m
Impulse counter: 1, 2, 3 (jumper)
Pyro element: dual PIR-Element
Term of alarm: min. 2,2 seconds
Operating temperature: -10°C bis +55°C
Stock temperature: -20°C bis +60°C
Dimensions (HxWxD): 107x60x48mm
Weight: 80g
LED display: eligible (jumper)