Genie COMHDMI User manual

Quick Start Guide
Please read these instructions carefully before operating the unit
and keep for further reference. All the examples and pictures used
here are for reference only. The contents of this manual are subject
to change without notice.
Composite to VGA / HDMI
Converter Kit
COMHDMI

Quick Start Guide Composite to VGA / HDMI Converter Kit
2
The Genie COMHDMI is a CVBS to HDMI / VGA converter that supports stereo
audio for CVBS and VGA output. It’s an easy to use device that supports OSD (On
Screen Display) menu to show the current setting status on the connected monitor
as well as supporting auto memory function to restore the previous user’s settings.
Features
• Converts CVBS to HDMI or VGA signal CVBS
• Resolution up to @50/60Hz for CVBS input, 1080p for HDMI & VGA output
• Built-in stereo audio input and output
• Supports auto memory
• Supports OSD menu show resolution, brightness, contrast, saturation, hue
Specifications
Dimensions
Supports
Video Format HDMI, VGA, CVBS
Maximum HDMI
Resolution 1080p @ 60Hz
Maximum VGA
Resolution 1920 × 1080 @ 60Hz
Maximum CVBS
Resolution 480i, 576i (NTSC/PAL)
Ports &
Interfaces
Video Input 1 x RCA
Video Output 1 x HDMI Type A, 1 × 15-pin Mini D-sub, 1 x RCA
Video Loop-out 1 x RCA
Audio Input 1 x RCA
Audio Output 1 x RCA, 1 × 3.5mm Phone Jack
Others
Power Supply DC 5V 2000mA Regulated
Power Consumption 1100 mA
Temperature
Operation: 0 to 55°C
Storage: -20 to 85°C
Humidity: Up to 95%
Dimensions 140 × 110.8 × 32mm
Weight 340g
140mm
32mm

Quick Start Guide Composite to VGA / HDMI Converter Kit
3
Application
Operation Controls and Functions
Button Function
MENU: OSD ON/OFF
UP: Select up or Increase setting value
DOWN: Select down or Increase setting value
SELECT: Select or setting.
OSD Menu
Resolution
Press SELECT button to setup resolution: 800×600, 1024×768, 1280×720, 1920×1080
Brightness
Press UP or DOWN button to decrease/increase from 0 ~100
Contrast
Press UP or DOWN button to decrease/increase from 0 ~100
Saturation
Press UP or DOWN button to decrease/increase from 0 ~100
Hue
Press UP or DOWN button to decrease/increase from 0 ~100
Factory Default value setting
Resolution: 800 × 600
Brightness: 50
Contrast: 50
Saturation: 50
Hue: 50
NOTE: Wrong Resolution setting will cause the picture to not display, please
initialise factory default value.
Camera
DVD
Monitor HDMI Monitor VGA Monitor

Quick Start Guide Composite to VGA / HDMI Converter Kit
4
Troubleshooting
1. Under OSD mode: OSD will be auto save after setup and turn off OSD mode
after 10 seconds.
2. OSD function only display on VGA, HDMI output mode.
3. Initialise factory default: Unplug the power adaptor, then press MENU button
and plug the power adaptor until LED blinking, then release MENU button.

Sales [phone]
Enquiries [email protected]o.uk
Website www.genieproducts.co.uk