Geoidsoft MOBILE GPS ONLINE TOJOIN GNSS-1000B User manual

_____________________________________________________________________________
Geoidsoft Inc. - Mobile GPS Online
3151 Strandherd Drive, P. O. Box 45535, Ottawa, ON K2J 0P9 Canada
https://www.mobilegpsonline.com e-mail: [e-mail]
Tel.: [phone]
TOJOIN GNSS Signal Repeater Kit
GNSS-1000B (60.01.001.0010)
GNSS-1000B GNSS Signal Repeater is designed to receive outdoor GNSS
satellite signals and then re-radiate them into indoor workplace or covered
space where the satellite signals cannot reach directly for testing GNSS
products indoor to lower the outdoor test costs, or keeping a GNSS device’s
positioning function running all time to avoid the so-called cold start time delay
issue for quick emergency action services.
Different from the GNSS-101, GNSS-1000B has two signal output ports. It can
send received GNSS signal to two transmitting antennas to double the
coverage area.
Different from the GNSS-1000, GNSS-1000B has an additional output signal
attenuation function. The signal attenuation range is step by step from 0 to
31dB. This function is very helpful for testing receiver’s signal sensitivity.

Geoidsoft Inc. - Mobile GPS Online
3151 Strandherd Drive, P. O. Box 45535, Ottawa, ON K2J 0P9 Canada
https://www.mobilegpsonline.com e-mail: [e-mail]
Tel.: [phone]
•Compact size/low cost/high performance
•Low power consumption
•Easy to install and operate
•High signal stability and strong anti-interference
•Re-transmitting range > 10m
•Optional to add GLONNAS and BD signals
GNSS-1000Bis ideal indoor GNSS (GPS/BD/GLONASS) signal coverage
solutions for
•Hangars
•Fire Stations
•Police Stations
•GNSS Labs
•GNSS Workshops
•GNSS Retail Stores
•GNSS Production Line
•GNSS mobile phone production line
•GNSS Repair Service
•GNSS Signal Reception in Underground Garage such as Tunnels and
Mines etc.

Geoidsoft Inc. - Mobile GPS Online
3151 Strandherd Drive, P. O. Box 45535, Ottawa, ON K2J 0P9 Canada
https://www.mobilegpsonline.com e-mail: [e-mail]
Tel.: [phone]
Installation Steps
1. Locate and mount the outdoor (receiving) antenna on the roof of
building horizontally with the best visibility of the sky. Make sure that
the antenna is installed vertical upward.
2. Fix the outdoor connection cable RG8 along the out wall. Connect one
terminator to outdoor antenna and another terminator to the lightning
protector. The cable length is customizable from 10m to 100m. In
some special environment, you may select PE or PVC plastic pipe to
protect the cable assembly.
3. Place the GNSS-1000B at a safe place and connect the lightning
protector to the GNSS-1000B signal repeater.
4. Connect the ground wire of the lightning protector to the ground.
5. Fix the indoor cable 3DFB along the ceiling of the operation room(s)
and mount the two transmitting antennas on the ceiling or crossbeam
above the center of the testing benches or workplaces.

Geoidsoft Inc. - Mobile GPS Online
3151 Strandherd Drive, P. O. Box 45535, Ottawa, ON K2J 0P9 Canada
https://www.mobilegpsonline.com e-mail: [e-mail]
Tel.: [phone]
6. Connect the two indoor (transmitting) antennas to the GNSS-1000B
signal repeater with the 3DFB cables. For a better performance, keep
the indoor cables shorter than 10m. If you need a longer indoor cable,
a signal amplifier is recommended to extend the cable.
7. Power on the GNSS-1000B signal repeater by plugging the AC (115V ~
240V) to DC 12V adapter. The system is ready for work.
Note: The inside transmitting antenna has to be located/mounted inside the
building with adequate isolation from the outdoor (outside) antenna to avoid
interference.

Geoidsoft Inc. - Mobile GPS Online
3151 Strandherd Drive, P. O. Box 45535, Ottawa, ON K2J 0P9 Canada
https://www.mobilegpsonline.com e-mail: [e-mail]
Tel.: [phone]
GNSS-1000B GPS Signal Repeater (60.01.001.0010)
Frequency Range
1575.42±10MHz (1190 ~ 2500 MHz)
Gain
20±1 dB
Noise figure
≤2.0 dB
1dB point of compression (dBm)
-10
Attenuation range
0~31 (1 dB per step)
Signal output
2
Impendence
50 Ω
VSWR
2:1 (max)
Interface Type
SMA
Power Supply
AC 110-220V/0.5A
Operating Temperature
-30~+85 °C
Dimension
225 x 215 x 80 mm
Weight
1.7 kg
GPS Receiving Antenna (60.06.010.0006)
Frequency range
1575.42±8MHz
Polarization mode
RHCP
Input impedance
50 Ω
VSWR
≤2.0
Axis Ratio
≤3 dB
Level coverage range
360°
Vertical coverage range
0°～90°
Gain（LNA）
38±2dBi
Gain Flatness
≤1.0
Noise figure
≤2.0dB
Operating voltage
3.3～5.0V
Working current
23mA
Connector type
N-Female
Dimension
Φ100mm×77mm
Working temperature
-45°C～+70°C
Storage temperature
-55°C～+85°C

Geoidsoft Inc. - Mobile GPS Online
3151 Strandherd Drive, P. O. Box 45535, Ottawa, ON K2J 0P9 Canada
https://www.mobilegpsonline.com e-mail: [e-mail]
Tel.: [phone]
Working humidity
0～95%
Wind resistance
60m/s（max.）
Installation mode
Screw fixation
Weight
2Kg（Including the installation of pipes
and fixtures）
GPS Transmitting Antenna (60.06.011.0003)
Frequency range
1575.42±5MHz
Polarization mode
RHCP
Input impedance
50 Ω
VSWR
≤1.2
Axis ratio
≤5dB
Level coverage range
360°
Vertical coverage range
0°～90°
Gain（LNA）
6dBi
Connector type
SMA
Dimension
Φ100mm×77mm
Working temperature
-45°C～+70°C
Storage temperature
-55°C～+85°C
Working humidity
0～95%
Wind resistance
60m/s（max.）
Installation mode
Screw fixation
Weight
0.5 Kg

Geoidsoft Inc. - Mobile GPS Online
3151 Strandherd Drive, P. O. Box 45535, Ottawa, ON K2J 0P9 Canada
https://www.mobilegpsonline.com e-mail: [e-mail]
Tel.: [phone]
1. 1 x GNSS-1000B GPS Signal Transponder (60.01.001.0010)
2. 1 x GPS Outdoor Receiving Antenna (60.06.010.0006)
3. 2 x GPS Indoor Transmitting Antenna (60.06.011.0003)
4. 1 x 10m RG8 outdoor coaxial cable, customizable from 10 to 100m
5. 1 x Lightning protector
6. 2 x 10m 3DFB indoor coaxial cable
7. 1 x AC to DC 12V power supply
8. 1 x Mounting accessories package
9. 1 x User manual (English version)