Gigabyte GS-W42G-P08R User manual

GS-W42G-P08R
Slide Rails and Rack Installation Instructions
v
Position the front section against the W42G-P08R, and make sure the mounting holes on the front section are aligned with the locating pins on the
side of the W42G-P08R. Assemble the front section onto the W42G-P08R and pull back to lock on. (NOTE: Make sure the below xed bracket is
locked on.) Do the same for the other slide.
xAfter withdrawing the front section, push back the middle section into the slide rail assembly. Push the latch and push back the middle section into the
slide rail assembly.
u
Remove the side cover. Push the blue latch and push forward the side cover to remove it.
uUnpack the slide rail assembly. vPull the slide rail assembly
until it reaches stop.
w
Push the latch between the front and middle section of the rail assembly,
then simultaneously withdraw the front section from slide rail assembly.
1Preparing the Slide
Rail Assembly
2Installing the Front
Section of the Slide
Rail onto the W42G-
P08R
Latch on the middle section

GS-W42G-P08R
Slide Rails and Rack Installation Instructions
v 
The front side and rear side assembly methods are the same. Attach the mounting bracket to the rack posts. Then lock on and push
down. Do the same for the other slide.
u
Pull out the slide rail assembly
on your rack until it stops.
u
Position the slide rail assembly in your rack and attach the mounting bracket to the rack posts. Then lock on and push down.
4Installing the W42G-
P08R onto the Rack
3Attaching the Slide
Rail Assemblies to
the Rack
vAlign the front section of the
W42G-P08R with the rail
assembly and insert it.
(NOTE: You should insert the left
and right slides simultaneously
to prevent any stuck during the
insert process.)
wInstallation completed.

GS-W42G-P08R
Slide Rails and Rack Installation Instructions
u
Push the latch on middle section of both sides and push the W42G-P08R back into rack to complete.
5Sliding the W42G-
P08R Back into the
Rack