Gigabyte S12-P10R User manual

S12-P10R/S12-P04R/S12-P04S
Slide Rails and Rack Installation Instructions
wAfter withdrawing the front section, push back the middle section into the slide rail assembly. Push the latch and push back the middle section into the
slide rail assembly.
u 
Position the front section against the S12 server and make sure the mounting holes on the front section are
aligned with the locating pins on the side of the server. Assemble the front section onto the S12 series server
and pull back to lock on. (NOTE: Make sure the below xed bracket is locked on.) Do the same for the other
slide.
uUnpack the slide rail assembly.
Pull the slide rail assembly until
it reaches stop.
vPush back the white latch on the front section of the slide rail assembly and simultaneously withdraw the front
section from the slide rail assembly.
1Preparing the Slide
Rail Assembly
2Installing the Front
Section of the Slide
Rail onto the S12
Series Server
Fixed bracket
Latch on the middle section

S12-P10R/S12-P04R/S12-P04S
Slide Rails and Rack Installation Instructions
v 
Unleash the metal clip to lock
on the rail assembly.
u 
Position the slide rail assembly in
your rack and align the mounting
bracket to the rack posts. Then
pull the metal clip and place the
slide rail assembly onto the rack
posts.
4Installing the S12
Series Server onto
the Rack
3Attaching the Slide
Rail Assemblies to
the Rack w
The front side and rear side assembly methods are the same. Pull the
metal clip and place the slide rail assembly onto the rack posts. After
making sure the mounting brackets is xed, unleash the metal clip to
lock on the rail assembly. Do the same for the other slide.
u
Pull out the slide rail assembly on your rack until it stops. v  Align the front section of the S12 series server with the rail assembly
and insert it. (NOTE: You should insert the left and right slides
simultaneously to prevent any stuck during the insert process.)
wInstallation completed.

S12-P10R/S12-P04R/S12-P04S
Slide Rails and Rack Installation Instructions
u
Pull the blue latch on the middle section of both sides and push the S12 series server back into the rack to complete.
5Sliding the S12
Series Server Back
into the Rack