Gigaset 1000 TAE Operating instructions

How do I register a G1000 TAE to a G3035, G3035 ISDN, G4035 or G4135 ISDN base?
1. The Gigaset 1000 TAE has to be switched off (unplug it
from the power outlet).
2. On the base station
Open the menu, press key .
3. Select "Settings" with display key . Confirm with display
key .
4. Select "System settings" with display key . Confirm with
display key .
5. Select "Register device". Confirm with display key .
6. Enter the PIN (this is set to 0000 in the factory) and confirm
with display key .
Seite 1 von 2Gi
g
aset 1000TAE 3035 isdn re
g
isterin
g
05.03.2010file://F:\docs\En
g
lish\DP\Bedien
p
rozeduren\anmelden
_
3035isdn
_g
1000tae.htm

7. Register through a telephone or fax machine:
Lift the handset from its cradle.
Plug the 1000 TAE back into the power outlet (you
should hear a single tone).
Press key 7 (you should hear a single tone).
Enter the base station number, i.e. 1 (you should hear
a single tone)
Enter the 4 digit System Code of the base station.
Replace the handset in its cradle.
The connected telephone or fax machine will ring.
Pick up the handset. You will hear a beeping register
tone. (It is searching for the base station. This can
take a few seconds).
Wait until either:
1. a single tone is heard (to signal that the
registration is accepted).
2. or 4 short tones are heard (to signal that the
base is not found, the system code is not
accepted, or there is not room for any more
devices in the base) .
Replace the handset in its cradle.
When the registration is successful, the internal number will
be assigned automatically by the base!
Seite 2 von 2Gi
g
aset 1000TAE 3035 isdn re
g
isterin
g
05.03.2010file://F:\docs\En
g
lish\DP\Bedien
p
rozeduren\anmelden
_
3035isdn
_g
1000tae.htm