Gigatek DSP840 User manual

TM951041
Customer Display
**DSP840**
Installation Manual

1
Required Items
The following items are used to attach the Display to the Stand.
Remark: CABLE TO PRINTER (WAS-1539) is an optional item.
CABLETO PC DISK
SCREW BAG POWER CABLE FROM PC
ACCESSORY UNIT (DSP840)
EXTENSIONSUPPORT(DSP840)
PILLAR C
PILLAR B
PILLARA
DISPLAYSTAND
WAS-1540
WAS-1539
CABLE TO PRINTER

2
Assembling Steps
1. Get the Stand and the Stand Plate.
2. Get the DISPLAY unit and place the Cable from the Display
through the extension pillars to the Stand.
When extending the height of the Stand, attach the extension
pillars with different heights: Low, Mid-low, Mid-high and
High shown as below to the Stand.
L
ow
Mid
-
l
ow
Mid
-
hi
g
h
Hi
g
h
Pill
ar
A
Pill
ar
B
Pill
ar
C
Pill
ar
A
Pill
ar
C
Pill
ar
B
Stand Stand Plate

3
3. Insert the tab on the Display (or the extension Pillar) into the
hole on the Stand until you feel it clicked.
4. Connect the cable from the Display to the RJ connector (TO
DSP) inside the Stand until you feel it clicked.
Also connect the enclosed D-connector cable (CABLE TO
PC) to the “ To Host ” connector and plug the power cable
(POWER CABLE FROM PC) into the DC Jack (DC 12V)
and connect the optional Printer D-connector cable (CABLE
TO PRINTER) to the “ To Printer ” connector when needed.
Note: CABLE TO PRINTER (WAS-1539) is an optional item.
You may order it when needed.

4
5. Cover the Stand Plate back and fasten the screws.
6. You may use the enclosed mounting screws (one Special
screw and two Wood screws) to fix the Display on the
wooden table surface.
Get the Mounting hole on the Stand Plate to fit the Special
screw first and then fix the two Wood screws.
Mounting hole to fit
the special screw
Wood screw
Special screw
Wooden table surface

5
The Display/Pillar/Stand Dimensions
Low

6
The Display/Pillar/Stand Dimensions
Low Mid-low Mid-high High

7