Gill 730183 User manual

800-637-3090
www.gillathletics.com
inst730183
730183 - FUSION 8x10 STARTING BLOCK
2/18/2022
All rights reserved. Page 1 of 3
Copyright 2021 by Gill Athletics.
INSTRUCTIONS
Carrying handle
Pedal pads are 8" x 10"
to four positions.
Pedal angle adjusts
False start bracket
Precise and consistent foot placement is
ensured using the integrated pedal markings.
Pedals are adjustable to 30°, 40°, 50°, and 60°
settings. Angled spikes in the base of the pedals
guarantee a start with absolutely no slipping.
Built in handle allows for easy carriage.
Pedal pads are available in the following colors:
- Royal Blue
- Red
- Orange
- Black
- Green

www.gillathletics.com
Copyright 2021 by Gill Athletics.
All rights reserved.
800-637-3090
2/18/2022
inst730183
Page 2 of 3
730183 - FUSION 8x10 STARTING BLOCK
INSTRUCTIONS
Pedal Plate
Pedal Pad
The FUSION starting block is shipped unassembled.
The following tools are needed:
- Needle Nose Pliers
- Spike Wrench
- Allen Key (provided)
1. Pedal pads
Set the angle of the pedal to the 60 position.
Insert the tabs on the pedal pad into the holes in the pedal plate.
Use one hand to press on the pedal pad. Use the other hand to
gently pull the tabs through the holes with needle nose pliers.
Gently wiggle the tab to help it through the hole. Be careful not
to pull the tab off of the pedal pad.
2. False start bracket
Fasten the false start bracket to the back of the rail with the
flat head screw provided.
Make sure that the "teeth" of the rail are pointing away from
the false start bracket.
3. Pedals
Slide each pedal onto the rail so that the pedal pad is facing
towards the open end of the rail.
Fasten the handle to the front of the rail with the flat head
screw provided.
4. Handle
Flip the starting block over and install the spikes into the
bottom of each pedal.
5. Spikes
False Start Bracket
Rail
M8 x 16mm Flat Head Cap Screw
M8 x 16mm Flat Head Cap Screw
Rail
Handle

www.gillathletics.com
Copyright 2021 by Gill Athletics.
All rights reserved.
800-637-3090
2/18/2022
inst730183
Page 3 of 3
730183 - FUSION 8x10 STARTING BLOCK
INSTRUCTIONS
Replacement Parts
REPL00043
Pedal Set Screws QTY 10
7301812
Includes:
Right & Left Pedal with Pedal to Rail Connectors
Handle & Rear Bracket
Handle & Rear Bracket Screws
7301831C02 - Royal Blue
7301831C03 - Red
7301831C05 - Orange
7301831C12 - Black
7301831C15 - Green
73016504
Spike Kit
includes 16 spikes
7301813
Rail