Ginnys 775576 User manual

ELECTRIC STEAM IRON
User Guide
Item: 775576
Ginnys.com • 800-544-1590
Facebook.com/GinnysBrand
Pinterest.com/GinnysBrand
BRAND

TABLE OF CONTENTS
Important Safeguards 3
Electrical Safety and Specicaons 4
Get to Know Your Steam Iron 5
How to Operate 6–8
Cleaning & Care 9
Troubleshoong 10–11
Warranty 12
____________________________________________________________
____________________________________________________________
Thank you for purchasing a Ginny’s Brand Electric
Steam Iron. Ironing chores will be easier and faster
with this iron in your hand! The nonsck soleplate
and retractable cord make it more ecient to use and
simpler to store. The steam control allows you to use
as much, or as lile as you like—when you want to—
and the self-clean buon helps eliminate buildup to
keep your iron working smoothly!
2Ginnys.com 800-544-1590
____________________________________________________________
____________________________________________________________

IMPORTANT SAFEGUARDS
READ CAREFULLY BEFORE USING AND SAVE THESE INSTRUCTIONS!
• FOR HOUSEHOLD USE ONLY. DO NOT USE THIS APPLIANCE FOR OTHER
THAN ITS INTENDED USE.
• Remove all packaging materials and labels before rst use.
• A short cord is provided to reduce the hazards resulng from tripping
or entanglement. DO NOT drape the cord over a counter or tabletop
where it can be pulled on or tripped over. DO NOT wrap the cord ghtly
around the appliance, as this could cause the cord to fray or break.
• We DO NOT recommend using an extension cord with this appliance.
However, if an extension cord is used, the marked electrical rang should
be at least as great as the electrical rang of this appliance.
• CLOSE SUPERVISION IS NECESSARY WHEN USING THIS APPLIANCE NEAR
CHILDREN.
• DO NOT leave iron unaended while hot or on an ironing board. Burns
can occur from touching hot parts, hot water or steam.
• A re may occur if this appliance is used near ammable materials,
including curtains, towels, walls, etc. DO NOT place the appliance or its
cord on or near a heated surface or in a heated oven.
• Always use this appliance on a stable, dry, heat-resistant surface.
• DO NOT use near water.
• DO NOT use an accessory or aachment not recommended by Ginny’s,
as this may cause injury or damage the appliance.
• When the iron is in use, keep hands and hair away from the hot
soleplate and hot steam.
• Use cauon when moving a hot iron.
• DO NOT let cord touch hot soleplate.
• Unplug this iron from the electrical outlet before adding water.
• DO NOT use outdoors.
• Turn o and unplug this iron when not in use.
• Let iron cool completely before storing.
• THERE ARE NO SERVICEABLE PARTS INSIDE THIS APPLIANCE.
• DO NOT USE AN APPLIANCE WITH A DAMAGED CORD OR PLUG, OR
AFTER THE APPLIANCE MALFUNCTIONS OR HAS BEEN DAMAGED IN ANY
MANNER.
• Appliances/tools contain valuable materials that can be recycled.
Dispose of your old appliances/tools using appropriate collecon
systems in accordance with federal and local regulaons.
3
Facebook.com/GinnysBrand

ELECTRICAL SAFETY
SPECIFICATIONS
This appliance is equipped with a polarized plug in which 1 prong is wider
than the other. This is a safety feature to reduce the risk of electrical shock.
The plug will t into a polarized outlet only 1 way. If you are unable to
insert the plug into the outlet, try reversing the plug. If it sll does not t,
contact a qualied electrician. DO NOT aempt to modify the plug in any
way. Ginny’s cannot accept any liability for damage or injury resulng from
failure to observe these safety procedures.
POWER RATING 120V, 60Hz, 1200–1600W
CORD LENGTH 72"
DIMENSIONS 5" W x 5½" H x 12¼" D
MODEL HG-5012
4Pinterest.com/GinnysBrand

GET TO KNOW YOUR STEAM IRON
5
Ginnys.com 800-544-1590
1. Spray Nozzle
2. Water Fill Door
3. Spray Buon
4. Burst of Steam Buon
5. Steam Control Lever
6. Grip
7. Temperature Control Dial
8. Cord Retract Buon
9. Retractable Cord Cover
10. Lights (Power and Preheat)
11. Water Tank
12. Self-Clean Buon
13. Base
14. Nonsck Aluminum Soleplate
15. Water Maximum Line
9
3
2
1
8
765
4
12
13
14 11
10
MAX
15

HOW TO OPERATE
6
Ginnys.com 800-544-1590
TEMPERATURE CONTROL DIAL
Turn the temperature control dial to select the desired fabric seng. The
preheat light will come on. When the iron reaches the selected
temperature the preheat light will go o.
ANTI-CALC SYSTEM
A special lter inside the water tank soens the water and prevents scale
buildup in the soleplate. The lter is permanent and does not need
replacing. USE TAP WATER ONLY. Use of dislled or demineralized water
may damage the an-calc system.
ANTI-DRIPPING SYSTEM
The iron automacally stops steaming when the temperature is too low (to
prevent water from dripping out of the soleplate).
AUTO SHUT-OFF (indicated by power light blinking)
1. An electronic safety device will automacally switch the iron o if it has
not been moved in 30 seconds in a horizontal posion.
2. If in a vercal posion, the iron will automacally switch o aer 8
minutes of no movement.
3. When the iron is picked up again, the power light and the preheat light
will turn on (indicang the iron is heang up again). The iron is ready for
use when the preheat light goes out.
SELF-CLEAN BUTTON
1. With a full water tank, every 10–15 days, push the steam control lever to
MIN.
2. Plug the cord into an electrical outlet and set the temperature control
dial to MAX .
3. When the preheat light goes o, hold the iron over a sink and unplug.
4. Hold the self-clean buon down and water will drip down from the
steam holes in the soleplate.
5. Gently shake the iron back and forth. Impuries and akes (if any) will
be ushed out with the water.
6. When the water tank is empty, release the buon and set the iron aside
to cool and dry.

Ne: It is normal for a small amount of smoke or smell to be produced
the rst me this iron is used. This should not persist aer the
rst few minutes of operaon.
FILLING THE WATER TANK
1. Ensure the iron is unplugged and set the temperature control dial to OFF.
2. Sit the iron upright (on the retractable cord cover) so the water ll door
is on top.
3. Open the door and ll the water tank with tap water to the maximum
mark. DO NOT ll above MAX.
4. Securely close the water ll door.
SELECTING TEMPERATURE
1. Follow the ironing instrucons on the fabric care label:
2. If there is no care label, but you do know the type of fabric, use the
following table as a guide.
Ne: If a garment consists of mulple fabrics, always select the
temperature needed for the most delicate fabric.
HOW TO OPERATE
7
Facebook.com/GinnysBrand
Fabric Temperature Seng Temperature
Silk ●Low
wool ●● Medium
Coon, linen ●●● High

8
Pinterest.com/GinnysBrand
HOW TO OPERATE
Ne: When using steam for the rst me, DO NOT direct the
steam toward the item to be ironed. Factory dust may be
released from the steam holes on the boom of the soleplate.
USING STEAM
1. Place the iron in a vercal posion. Unplug and set the temperature
control dial to OFF.
2. Fill the water tank (see page 7).
3. Pull out the retractable cord and insert the plug into an electrical outlet.
The blue power light will come on.
4. Turn the temperature control dial to STEAM. The red preheat light will
come on, indicang that the iron is heang up.
5. When the preheat light turns o, the set temperature has been reached
and the iron is ready to use. During ironing, the preheat light will
automacally switch on and o as the thermostat maintains the set
temperature. It is ne to connue ironing during this process.
6. Move the steam control lever to the desired posion: MIN (0), MED or
MORE.
7. Steam will be produced as soon as the iron is held horizontally.
8. When nished, turn OFF and unplug the iron,
9. Press the cord retract buon to retract the cord.
USING BURST OR VERTICAL STEAM
1. With water in the tank, press the burst of steam buon to generate a
powerful burst of steam that can penetrate the fabric and smooth the
most dicult creases.
2. By pressing the burst of steam buon at intervals, you can also iron
vercally (for hung curtains or garments).
USING SPRAY
With water in the tank, press the spray buon to spray water from the spray
nozzle to dampen fabric. You may have to pump the spray buon several
mes at rst to start the spraying funcon.
USING A DRY IRON
DO NOT add water to the tank for ironing without steam or spray.

9
Ginnys.com 800-544-1590
CLEANING & CARE
1. Make sure the iron is unplugged and cool before aempng to clean.
2. Wipe o the soleplate with a warm, soapy cloth and dry. DO NOT use
abrasive brushes or pads, or harsh cleaning soluons.
3. Wipe the exterior of the iron with a damp cloth.
4. DO NOT put vinegar or other descaling agents in the water tank!
5. If scale buildup blocks the steam vents on the soleplate, dislodge using a
toothpick or small brush.
6. Use the self-clean funcon once every 10–15 days (see page 6).
7. DO NOT immerse any cord, plug or electrical appliance into water.

TROUBLESHOOTING
10
Ginnys.com 800-544-1590
Not hot enough Enough me has not
been allowed for iron
to heat properly
The temperature dial
is set too low
The iron is not plugged
in
Wait unl the preheat
light has gone o.
Set the temperature
dial to a higher
temperature.
Ensure the iron is
plugged in.
Leaking water from
the soleplate
The temperature dial
is set too low
The iron is not plugged
in
There is too much
water in the water
tank
Set the temperature
dial to a higher
temperature.
Ensure the iron is
plugged in.
Pour out the excess
water unl the water
line is below MAX.
No burst of steam The burst of steam
buon has been used
too oen within a
short period of me
The iron is not hot
enough
Connue ironing in the
horizontal posion and
wait 5 seconds before
using the burst of
steam buon again.
Set the temperature
dial to a higher
temperature.
Problem Cause Soluon
(connued on next page)

TROUBLESHOOTING
11
Facebook.com/GinnysBrand
Not making steam There is too much water
in the water tank
The water tank is empty
The temperature dial is
set too low
Pour out the excess
water unl the water
line is below MAX.
Fill the water tank.
Set the temperature
dial to a higher
temperature.
Not making enough
steam
The temperature dial is
set too low
The steam control lever
is not set to the proper
posion
The water tank is empty
The steam holes are
blocked
Set the temperature
dial to a higher
temperature.
Reset the steam
control lever to the
proper posion.
Fill the water tank.
Use the self-clean
buon.
Not spraying The water tank is empty Fill the water tank.
Problem Cause Soluon

WARRANTY
Ginny’s warrants this product free from defects in material and
workmanship for one year from provable date of purchase.
Within this warranty period, Ginny’s will repair or replace, at its opon,
defecve parts at no charge, provided the product is returned, freight
prepaid with proof of purchase to Ginny’s. Allow 2–4 weeks for return
shipping.
This warranty does not cover improper installaon, misuse, abuse or neglect
on part of the owner. Warranty is also invalid in any case that the product is
taken apart or serviced by an unauthorized service staon.
This warranty gives you specic legal rights and they may vary from
state to state.
THE FOREGOING WARRANTIES ARE IN LIEU OF ALL OTHER WARRANTIES AND
CONDITIONS, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THOSE
OF MERCHANTIBILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Ginny’s, Inc.
1112 7th Avenue
Monroe, WI 53566
Customer Service: 800-544-1590
8:00 a.m. to Midnight CST, Monday through Friday
12
Ginnys.com 800-544-1590