GJD D-TECT X GJD397 User manual

PACKAGE CONTENTS
• 1 x D-TECT X Repeater & 1A PSU in IP65 Housing
• 1 x Installation Manual
INTRODUCTION
The D-TECT X Repeater can be used to extend the range
of a D-TECT X detector, or to boost signal in a poor recep-
tion area.
D-TECT X REPEATER
The D-TECT X Repeater must be placed within 500 metres
line of sight between the D-Tect X detector(s) and D-TECT
X Receiver(s). The unit will repeat all signals from D-TECT
X detectors within range and as such does not require any
programming to function.
SPECIFICATIONS
Range 500m (line of sight)
Tamper Switches Front and rear tamper switches:
case open and removal from wall
Wireless Frequency 868 MHz <25 mW
Current 23mA (12V nominal)
Operating Temperature -10 to +50 Centigrade, Conformal
coated electronics for increased
stability
Housing High impact, ame retardant, UV
stabilised Polycarbonate
Protection Rating IP65
Dimensions W210mm x H180m x D79m
Weight 750grams NET, 880grams
GROSS
Certications
POWER SUPPLY MODULE
The GJD Power Supply Module provides a 12 VDC output
from a 230 VAC input that enables the D-Tect X Repeater
to be conveniently installed with easy access to a mains
supply.
INSTALLATION
• The Power Supply Module requires a 230 VACsupply
on the LIVE input and a neutral on the N connection.
• An EARTH connection is also provided for the termi-
nation of the earth conductor. Ensure this connection
is securely made.
• Connect the positive and negative terminals of the 12
VDC output to the corresponding inputs of the D-Tect
X Repeater.
IMPORTANT SAFETY REQUIREMENTS
• The Power Supply Module MUST be installed and
maintained by suitably qualied engineers and the
installation MUST comply with all relevant code of
practice and regulations.
• All mains supplies to the module MUST be via a
Residual Current Device (RCD) and an overload
protection device.
• All mains supplies to the module MUST be
disconnected before removing the cover.
SPECIFICATIONS
Mains Supply Input 230 VAC, 50 Hz
12 VDC Output 12 VDC, 1A
5 VDC Output 5 VDC, 0.1A
Operating Temperature -10 - +50 degrees centigrade
D-TECT X Repeater
GJD397 Repeater
SIMPLIFIED EU DECLARATION OF CONFORMITY
Hereby, GJD Manufacturing Ltd declares that the radio
equipment type GJD397 D-Tect X Repeater is in
compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available
at the following internet address: gjd.co.uk

Unit 2 Birch Business Park, Whittle Lane, Heywood, Greater Manchester, OL10 2SX,
www.gjd.co.uk [email protected] [phone]
ENGINEER NOTES