The GC-RG1 employs a 3 meter (~10ft) cable with a 3.5mm jack for easy
installation and connection to the GC-IRE or Xantech distribution block. The cable
may be extended to several 100 meters providing the total cable capacitance does
not exceed 15,000pF. A typical CAT5 or audio cable is 60pF per meter permitting
250 meter (~ 800ft) cable run without signal amplification.
Specifications:
•Use with the GC-IRE To digitizes IR signals.
•Xantech compatible Yes
•IR frequencies capture range 30 KHz to 80 KHz
•Capture distance 8m - 12m (26' - 40') remote dependent
•Case size HxWxL. 10mm x 21mm x 25mm (.40" x .82" x .95")
•Cable type 3 meter shielded with 3.5 mm stereo jack
•IR signal indicator Blue LED
•Viewing angle (left, right) 30 degrees
•Viewing angle (top, bottom) 10 degrees
•Power requirements 7V - 15V@3mA (no load)
•Output impedance (short-circuit protected) 150 Ohms
Note: A power supply is not required when used with the GC-IRE.
Global Caché, Inc.
160 East California Street, PO Box 1659
Jacksonville, Oregon 97530
Phone (541) 899-4800
Fax (541) 899-4808
www.globalcache.com
Copyright ©2007 Global Caché, Inc. All rights reserved.
PN: 122106-01 ver3/Information subject to change without notice.