.
1 | P a g e
GPS, GPS-FC-3-BAS, Global Plasma Solutions and its logos are trademarks of Global Plasma Solutions, Inc.
GPS-FC-3-BAS IOM.docx ©2019 Global Plasma Solutions, Inc. www.globalplasmasolutions.com
Thank your choosing the GPS-FC-3-BAS™from Global Plasma Solutions. The GPS FC-3-BAS is designed to be
mounted inside of fan coils, heat pumps, ductless mini splits, and air handlers up to 3,200 CFM or 8 tons. There are
BAS terminals provided.
HARDWARE PROVIDED BY GPS
•GPS-FC-3-BAS unit
•Fuse
HARDWARE REQUIRED BY INSTALLER
•Mounting screws
•Electrical connectors
•Double sided tape
INSTALLATION LOCATION
GPS recommends the GPS-FC-3-BAS be installed downstream from the filter to prevent unnecessary build up of
particulates on the carbon fiber needle tips. Below is a list of locations to mount the GPS- FC-3-BAS in the
preferred order.
1. Downstream from the filter, and prior to the blower and cooling coil. This helps prevent particulate build
up and provides maximum bacteria control.
2. Downstream from the filter and the blower, prior to the cooling coil
3. Downstream from the filter, blower and coil,
4. Prior to the filter. Particulate build up will be greater, so cleaning will need to be done more frequently .
CAUTION: MAKE SURE POWER IS DISCONNCTED TO THE HVAC EQUIPMENT BEFORE INSTALLATION
MECHANINCAL INSTALLATION
1. Select a location for installation. The GPS-FC-3-BAS needs to be perpendicular
to the air flow (air should flow past needles like a ball through the goal posts).
The GPS-FC-3-BAS should be mounted so that the needles are exposed to
airstream.
•The ideal location on typical split systems is on the blower housing, the side
opposite the blower motor. The housing of the GPS-FC-3-BAS should be so
that the needles extend slightly above the side of the blower housing.
•The ideal location for ceiling cassette units is on the fan side of the protective
screen/ grill.
•The ideal location for mini split systems is after the filter and behind the coil, mounted to the wall plate.
•The ideal location for ducted module is on the intake side after the filter between the blower housings.
2. Secure the GPS-FC-3-BAS, if attaching to sheet metal use self-taping screws if possible. NOTE: Inspect the
other side of sheet metal to make sure screws will not damage refrigerant lines, wires, or other
components.When attaching the GPS-FC-3-BAS to a grill or screen nylon ties may be used.
3. The GPS-FC-3-BAS needles should not be touching any metal surface or wires. Move and secure any wires that
may contact the needles.
NOTE: THE NEEDLES MUST BE 2 INCHES AWAY FROM METAL SURFACES TO PREVENT ARCING
