Globe Chefmate C24GG Manual

995095 Gas Conversion Manual Griddle 02/23/2015 Rev -
For Installation and Service on Your Gas Griddle:
1. Visit our website at www.globefoodequip.com
2. Or call the Globe Service Department at 937-299-8625 and ask for contact
information for your local service company.
Serial #:
Visit our website for information on additional products available from Globe.
www.globefoodequip.com
Slicers, Mixers, Countertop Cooking Equipment, Meat Choppers & Scales
These instructions are for conversion of the GAS GRIDDLE. The instructions provide in this kit are for the
conversion of Natural Gas to L.P. gas and refer to the conversion of the unit and kit provided. An authorized
licensed technician must be called to preform the complete conversion of the unit. Failure to properly convert this
unit, can result in serious injury, property damage, or death and will void warranty.
- IMPORTANT NOTICE -
Conversion Kit Instructions for the
Chefmate™ Gas Countertop Griddle
Models: Manually Controlled: C24GG & C36GG
C24GG
Pg 1 of 4

Rev. - 02/23/2015 995095 Gas Conversion Manual Griddle
Gas Griddle (Manually Controlled)
Conversion Kit Instructions
Do not attempt gas conversion by yourself. Gas conversion of your unit is to be
made by a certied/licensed technician. Locate an authorized Globe servicer at
www.globefoodequip.com
CONVERSION
Instructions are for conversion from Natural Gas to Propane (L.P.) on all models. The conversion should be
done before connecting the unit to the gas supply. Units are shipped from the factory equipped for use on
natural gas. Parts necessary for L.P. (liquid propane) are provided with the unit. Turn off the main gas supply
before doing any maintenance.
1. Remove the knobs and front panel.
2. Unscrew bolts and pilot valve, then
remove the manifold.
3. Replace the orice ttings into the valve.
Note: Unit Number on side of orice
ttings.
4. Replace the front panel and knobs.
5. Before installing the included convertible
regulator, unscrew the octagon cap. You can read
(NAT) on the plastic insert attached to the head of
the cap; ip it over and snap back in place.
Convertible
regulator with
octagon cap.
Unscrew from
regulator.
Pull off
plastic insert
from octagon
cap and
reverse the
plastic insert
position so
that the L.P.
position is
attached to
the octagon
cap head.
L.P. Position
of insert.
Regulator
is now
converted to
L.P.
6. Continue with installation.
L.P.
L.P. Position
NAT L.P.
Pg 2 of 4
CAUTION FOR SERVICERS: If you convert from one gas type to another, please adjust to the correct gas
pressure before use. Also, be sure to indicate the correct gas markings on all equipment tags/lables.

995095 Gas Conversion Manual Griddle 02/23/2015 Rev - Pg 3 of 4
Model Rated
Input
Per
Burner
(BTU/
HR)
Elevation Elevation Elevation Elevation Elevation
0-2000 ft 2000 - 4000 ft 4000-6000 ft 6000-8000 ft 8000-10000 ft
Nat LP Nat LP Nat LP Nat LP Nat LP
Griddle (Manual)
30000 K00411 (# 39) K00412 (# 50) K00630 (# 40) K00631 (# 51) K00635 (# 41) K00631 (# 51) K00632 (# 42) K00637 (#52) K00638 (# 44) K00637 (#52)
Gas Specications Table
Specications are subject to change without notice.

Rev. - 02/23/2015 995095 Gas Conversion Manual Griddle
Pg 4 of 4
© Copyright Globe Food Equipment Company 2015 Produced in the United States of America 01/13 All Rights Reserved
Globe and the Globe logo are trademarks or registered trademarks of Globe Food Equipment Company in the United States and/or other countries.
www.globefoodequip.com Specications are subject to change without notice.