GLP GPC Series User manual

MOUNTING / INSTALLATION MANUAL
1. APPLICATIONS
The LED power supplies are designed for the LED (Light Emitting Diode) Lamps used in indoor or outdoor, dust or damp
locations. GPV, GPVP, GPC, GPCP are in isolation class (they have no PE/FG wire).
2. IMPORTANT INFORMATIONS FOR THE INSTALLATION
• Before installation, please disconnect the power supply from mains and ensure it cannot be connected accidentaly.
• Keep free air convection around the power supply, don’t put any objects on it and keep at least 10-15cm space between
power supply and other heat emiter.
• Position other than indicated or working in high temperature ambient may cause internal components temperature
increasing, which results de-rating (see de-rating curve in datasheet)
• nput and output current rating wires, should be greater than internal unit’s wires
• n case of using waterproof wires connectors, please ensure, the connection is stable and doesn’t allow water to get into
• To connect power supply to the mains:
- connect ACL wire (brown or black) of the unit to mains Live AC (brown or black)
- connect ACN wire (white or blue) of the unit to mains Neutral AC (white or blue)
1 / 2
LED Power Supplies
GPC, GPCP, GPV, GPVP series
Mounting / Installation manual LED GPC/GPV R1.0, 15.05.2014
LED POWER
SUPPLY
LED POWER
SUPPLY
AC/L
AC/L
Circuit
breaker
Neutral wire ACN
(white or blue)
Live wire ACL
(black or brow )
AC/N
AC/N

• Maximum number of power supplies simultaneously connected to the one circuit breaker at 230VAC is shown below:
Model B10 B16 C10 C16
GPC-9 6 9 10 15
GPC-20 2 4 5 7
GPC-35 2 4 4 6
GPC-60 2 3 4 6
GPCP-20 2 4 4 6
GPCP-35 2 5 5 6
GPCP-60 5 8 8 14
GPV-12 6 9 10 15
GPV-20 2 4 5 7
GPV-35 2 4 4 6
GPV-60 2 3 4 6
GPV-100 1 1 1 3
GPVP-35 2 5 5 6
GPVP-60 2 3 4 6
3. CAUTION DURING INSTALLATION AND USING
• All the damages should be fixed by authorized personel only
• Do not remove housing of the power supply by yourself – risk of electrical shock
• Caution! Risk of irreversible damage. P67 power supplies should work only indoor or outdoor not exposed for rain and
sunlight
• Do not place power supply in high temperature or near to the heat emitters. For maximum ambient work and storage
tempeature, refer to datasheet
• Maximum load current and power cannot exceed rated (see datasheet)
• The power supply is a component designed for installing into whole system, so it cannot be treat as a independent device.
Final EMC tests results are obligatory for whole system, so the test must be done again, after mouting power supply into such
system
2 / 2 Mounting / Installation manual LED GPC/GPV R1.0, 15.05.2014
Distributor