pg. 6 For enquiries or support: visit www.gmcaircon.co.za or contact us on 012-661 1173
OPERATIONAL SAFETY GUIDELINES
WARNING!
Install the unit in rooms which exceed 10 m².
•If the supply cord is damaged, it must be replaced by the
manufacturer, or its service agent.
•Always operate the unit from a power source of equal voltage,
frequency and rating as indicated on the product identification
plate.
•Always use a power outlet that is grounded.
•Unplug the power cord when cleaning or when not in use.
•Do not operate with wet hands. Prevent water from spilling onto
the unit.
•Do not immerse or expose the unit to rain, moisture or any other
liquid.
•Do not leave the unit running unattended. Do not tilt or turn over
the unit.
•Do not unplug while the unit is operating.
•Do not use an extension cord or an adapter plug.
•Do not put objects or climb or sit on the unit.
•Do not insert fingers or other objects into the air outlet.
•Do not touch the air inlet or the aluminum fins of the unit.
•Do not operate the unit if it is dropped, damaged or showing signs
of product malfunction.
•Do not clean the appliance with any chemicals.
•The unit shall be installed in accordance with national wiring
regulations.
•The appliance shall be stored in a room without continuously
operation sources (for example: open flames, an operating gas
appliance or an operating electric heater).
•The appliance shall be stored so as to prevent mechanical damage
from occurring in a well-ventilated area.
•Be aware that refrigerants may not contain an odor.
•Pipe-work shall be protected from physical damage and shall not
be installed in an unventilated space, if that space is smaller than
10 m².
•Compliance with national gas regulations shall be observed.
•Keep any required ventilation openings clear of obstruction.
