Go Rhino Dominator 2 series User manual

Parts List
Qty.
Part #
Description
Torque
1
3
C0751
Driver Side Bracket
2
3
C0752
Passenger Side Bracket
3
12
M8-1.25 x 25mm Hex Bolt
15 Ft. Lbs.
4 4 M8-1.25 Hex Nut
5 4 M8-1.25 U-Nut
6 16 5/16" Flat Washer
7
12
5/16" Lock Washer
8
12
3/8"-16 x 1-1/4" Hex Bolt
30 Ft. Lbs.
9
12
3/8" Hex Nut
10
24
3/8" Flat Washer
11 12 3/8" Lock Washer
12 1 D24050D Driver Side Step
13
1
D24050P
Passenger Side Step
Installation Instructions
Dominator 2 Side Steps Part #D24052 (B-PS)
2014 Chevrolet Silverado 1500 Crew Cab
Do not attempt to install this product on any vehicle other than the one listed above!
Tool Required:
13mm & 9/16” Socket
13mm & 9/16” Wrench
Ratchet & Ratchet Extension
Tape Rule
Approximate installation time: 60 min
#1
Driver Side
#2
Passenger
Side

Installation
Step-1 This installation uses three brackets per side. Begin by installing the driver side front bracket. Measure
from the front fender bolt rearward approximately 14”, (Photo 1) and locate the M8 nut welded to the body pinch
mold and the M8 threaded insert in the rocker panel, (Photo 2).
Step-2 Attach one of the driver side brackets to the rocker panel and pinch mold using (2) M8 hex bolts, (2) 5/16”
lock washers and (2) 5/16” flat washers. Leave the bolts loose for final adjustment, (Photo 3).
#2
Driver Side
#1
Driver Side
#3
Driver Side
14”

Step-3 Install the driver side center bracket by measuring from the front fender bolt reward approximately 58 7/8”
and locate the hole in the body pinch mold and the plastic plug in the rocker panel, (Photo 4). Remove the plastic
plug from the rocker panel and install (1) M8 U-Nut in the rocker panel, (Photo 5).
Step-4 Attach one of the driver side brackets to the rocker panel using the U-Nut, (1) M8 hex bolt, (1) 5/16” lock
washer and (1) 5/16” flat washer, and to the pinch mold using (1) M8 hex bolt, (2) 5/16” flat washers, (1) 5/16”
lock washer, and (1) M8 hex nut. Leave the nut and bolts loose for final adjustment, (Photo 6).
Step-5 Install the driver side rear bracket by measuring from the front fender bolt reward approximately 75 1/8”
and repeat the above steps.
#5
Driver Side
#4
Driver Side
#6
Driver Side

Step-6 Attach the driver side step to each bracket using (2) 3/8” x 1 ¼” hex bolts, (4) 3/8” flat washers, (2) 3/8”
lock washers and (2) 3/8” hex nuts, (Photo 7).
Step -7 Align the side step with the vehicle and tighten all bracket and side step nuts and bolts.
Repeat the above steps to install the driver side brackets and side step. Remember to check and retighten the
nuts and bolts every six months.
#7
Driver Side