Go Rhino dominator d2 series User manual

QTY PARTS DESCRIPTION
6
5/16” U-NUTS
6 5/16” X1” HEX BOLTS
6 5/16” LOCK WASHERS
6
5/16” FLAT WASHERS
18 3/8” x 1 “ HEX BOLTS
18
3/8” LOCK WASHERS
QTY PARTS DESCRIPTION
18
3/8” FLAT WASHERS
18 3/8” HEX NUTS
3 C07P PASSENGER MOUNTING BRACKETS
3
C07D DRIVER MOUNTING BRACKETS
1 D24041P PASSENGER SIDESTEP
1
D24041D DRIVER SIDESTEP
INSTALLATION INSTRUCTIONS
STEP 1. Read the instructions completely before you begin the installation.
If the vehicle isequipped with factory running boards, remove the fasteners and running boards.
DOMINATOR 2 SERIES SIDESTEPS
ASSEMBLY & INSTALLATION INSTRUCTIONS FOR
PART NO. D24041
07-12 CHEVY/GMC 1500 EXTENDED CAB PICKUP 2/4WD
07-10 CHVEY/GMC 2500HD, 3500 4DR EXTENDED CAB 2/4WD
11-12 CHEVY/GMC 2500HD, 3500HD 4DR EXTENDED CAB P/U 2/4WD (Gasoline only)

STEP 2. This installation uses three mounting brackets per side. Begin by installing the passenger side
front mounting bracket. Measure reward from the front fender bolt approximately 14” and Locate the
single hole in the body pinch mold and the two holes in the rocker panel.
STEP 3. Remove the plastic plug from the rocker panel and install (1) 5/16” U-NUT as shown.
PLASTIC PLUG
3/8” X 1” HEX BOLT, FLAT WASHER, LOCK WASHER & HEX NUT
5/16” X 1” HEX BOLT, LOCK WASHER & FLAT WASHER
INSTALLED 5/16” U-NUT
BRACKET MOUNTING POINTS
C07P MOUNTING BRACKET
PINCH MOLD
ROCKER PANEL

STEP 4. Loosely attach one of the C07P mounting brackets to the rocker panel and pinch mold using the
5/16” and 3/8” fasteners as shown.
STEP 5. Locate the holes in the body for the center and rear mounting brackets. Measure rearward from
the front fender bolt 37 ¾” for the center and 67” for the rear bracket. Repeat steps 3 & 4 to install the
center and rear brackets.
STEP 6. Position D24041P passenger sidestep up to the vehicle and loosely attach it to the mounting
brackets using the 3/8” x 1” hex bolts, flat washers, lock washers and hex nuts.
D24041P SIDESTEP
PASSENGER SIDE FRONT
C07P MOUNTING BRACKETS
C07P MOUNTING BRACKET
3/8” X 1” HEX BOLTS, FLAT WASHERS, LOCK WASHERS & HEX NUTS

STEP 7. Tighten all mounting bracket and sidestep nuts and bolts.
STEP 8. Repeat the above steps to install the driver side mounting brackets and sidestep.