Goclever ORION 101 User manual

A104.2BK / ORION 101 Flashing Guide
1. Charge device battery
2. Install Phoenix Suit.
3. Open PhoenixSuit, and click „firmware”.
EUROPEAN HEADQUARTERS
EUROPEAN HEADQUARTERSEUROPEAN HEADQUARTERS
EUROPEAN HEADQUARTERS
GOCLEVER Sp. z o.o.
4A Sianowska Street 60-431 Poznan Poland
Tel: [phone] Fax: [phone]
[e-mail]

4. Select firmware file.
5. Connect device to PC in flash mode. To do this, You must keep pressing Volume up button
while connecting usb cable to device. Device must be turned off before You start.
Sometimes device is freezed with black screen, and it can't be recognized by PC.
In this case press power key for ~15s. It will turn off device. After it try to connect device with
volume key again.
EUROPEAN HEADQUARTERS
EUROPEAN HEADQUARTERSEUROPEAN HEADQUARTERS
EUROPEAN HEADQUARTERS
GOCLEVER Sp. z o.o.
4A Sianowska Street 60-431 Poznan Poland
Tel: [phone] Fax: [phone]
[e-mail]

6. If device is recognized, and drivers are installed correctly, phoenix suit will show question about
mandatory format. Click “yes”
7. After it, program will write new FW to device
EUROPEAN HEADQUARTERS
EUROPEAN HEADQUARTERSEUROPEAN HEADQUARTERS
EUROPEAN HEADQUARTERS
GOCLEVER Sp. z o.o.
4A Sianowska Street 60-431 Poznan Poland
Tel: [phone] Fax: [phone]
[e-mail]

8. After successful upgrading program shows this message :
9. Turn on device using power button. First time it can take ~ 5 minutes.
EUROPEAN HEADQUARTERS
EUROPEAN HEADQUARTERSEUROPEAN HEADQUARTERS
EUROPEAN HEADQUARTERS
GOCLEVER Sp. z o.o.
4A Sianowska Street 60-431 Poznan Poland
Tel: [phone] Fax: [phone]
[e-mail]