GOINTERNET Netcomm NF4V User manual

GoInternet Setup Guide for Netcomm NF4V Modem Router (VDSL)

To install the router:
Connect Router to power
Connect the DSL port on the router to a jackpoint on the wall
Connect Router to computer (i.e.: PC or laptop) via an ethernet cable.
Setting up for GoInternet
Basic and Fast – VDSL
To set the modem up for the Turbo plan:
Launch your Web Browser (e.g.: Internet Explorer, Chrome or Firefox).
Access the modem settings:
Type 192.168.20.1 into the address bar.
Press the ENTER key.

The login screen displays.
Login to the modem page:
Username
admin
Password
admin
If that Username and Password do not work you should RESET the modem to factory settings (see the instructions below).
Click the Log In button.

The modem’s Dashboard screen displays.
Configure the modem for GoInternet:

From the menu on the left, click Advanced Setup.
Remove all old WAN services if there are any present.
1. Click on WAN service.
2. Tick each interface that is present.
3. Click remove.

Check to see that there are no old PTM interfaces. If there are, remove them with the steps below:
Click PTM Interface
Tick the remove box(es)
Click remove.
Add your new PTM interface.
Click PTM Interface.2. Click the Add button under the PTM interface.

Enter the required settings for your new PTM interface. Leave all settings on defaults2. Click Apply/Save.

Add a new WAN service.
Click WAN service
Click Add

Select your new PTM interface.
Select ptm0\(0_0_100).
Click Next.

Enter a service name if desired.
Select PPP over Ethernet.
Enter Priority 0 and VLAN ID 10.
Change the service name if desired, or leave on the default and click Next.