Goldair FPG310 User manual

OPERATING INSTRUCTIONS
Grill Press
Model FPG310
FPG310: 220 - 240V~, 50Hz, 1500W, Grill Press

GENERAL CARE AND SAFETY GUIDE
Thank you for choosing a Goldair Electric Sandwich Maker. This Goldair appliance has
been designed and manufactured to high standards of engineering and with proper
use and care, as described in this leaflet, will give you years of useful service. Please
read these instructions carefully.
ALWAYS
✔Always ensure hands are dry before
handling the plug or the Sandwich Maker.
✔Always operate the Sandwich Maker on
a secure, dry, level surface.
✔Always allow adequate air space above
and on all sides for air circulation. Do not
allow the Sandwich Maker to touch
curtains, wall coverings, clothing,
dishtowels or other flammable materials
during use. Do not use under cupboards or
curtains.
✔Caution is required on surfaces where
heat may cause a problem – an insulated
heat pad is recommended.
✔Always be sure to unplug from the
socket when not in use and before
cleaning.
✔Always allow the Sandwich Maker to
cool before cleaning and storing.
✔Carry out regular checks of the supply
cord to ensure no damage is evident.
✔Return the Sandwich Maker after a
malfunction, or if it has been damaged in
any manner to an authorised electrician
for examination, repair or adjustment as
special purpose tools are required.
✔Take care not to scratch the special
coating of the cooking plate. Use a wooden
or heat resistant plastic spatula.
NEVER
✘Never touch hot surfaces.
✘Never use this appliance outdoors.
✘Never use this appliance for any
purpose other than its intended use. This
appliance is for household use only.
✘This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities or
lack of experience and knowledge, unless
they are supervised or have been given
instruction concerning the use of the
sandwich maker by a person responsible
for their safety.
✘Close supervision is necessary when the
appliance is near children.
✘Never leave the appliance unattended
when in use.
✘Never place this appliance on or near a
hot gas or electric burner or where it
could touch a heated oven or microwave
oven.
✘Exercise caution if using foodstuffs
containing sugar or products containing
jam or preserves, as the fillings may
become very hot.
✘Never immerse any part of the sandwich
maker, or cord set and plug in water or
any other liquid to protect against
electrical hazards.
✘Never use harsh, abrasive or caustic
cleaners to clean this appliance.
✘Never operate the appliance with a
damaged cord or plug, after it
malfunctions, or if it has been damaged in
any manner.
✘The sandwich maker is not intended to
be operated by means of an external timer
or separate remote-control system.
CAUTION:
THE SANDWICH MAKER GENERATES HEAT
AND STEAM DURING USE. PROPER
PRECAUTIONS MUST BE TAKEN TO
PREVENT THE RISK OF BURNS, SCALDS,
FIRES OR OTHER DAMAGE TO PERSONS.

COMPONENTS
FPG310
Non-Dividing
Non stick
cooking plates
Cool touch
handle and
housing
Cooking
Indicator
Non-slip
feet
Ready Indicator
Grill Plate Spatula
OPERATING YOUR SANDWICH MAKER
1. Clean the surface of the non-stick cooking plates with a damp cloth, then dry.
2. Place the Sandwich Maker on a flat, dry and level surface with the lid closed.
3. Plug the Sandwich Maker into a suitable power outlet, corresponding with the rating
label, 230-240V~.
NOTE: When using your Sandwich Maker for the first time, you may notice the
cooking plates smoke slightly. This is normal and will quickly disappear.
4. The red power “On” light will illuminate to indicate the Sandwich Maker is heating
up.
5. Prepare your sandwich while the appliance is heating up, buttering up to four pieces
of bread and preparing your desired filling.
6. When the green “Ready” light illuminates, your sandwich maker is ready to use.
Place two pieces of buttered bread onto the lower cooking plates, buttered side
down. Place filling on top of the bread.
7. Add the top slice/s of bread and carefully close the Sandwich Maker lid, clipping the
handles together with the locking latch. Note: The green light will turn on and off,
while cooking to indicate the temperature is being maintained. Toasting will take
approximately 3 minutes depending on individual preference and the type of bread
and/or filling being used.
8. When the sandwich is cooked, remove using a wooden or heat resistant plastic
spatula. Never use metal utensils as these can damage the non-stick surface.
CAUTION: STEAM MAY BE EJECTED FROM BETWEEN THE PLATES DURING THE
COOKING PROCESS. TAKE CARE NOT TO COME INTO CONTACT WITH THE STEAM AS
IT MAY CAUSE BURNS.
ENSURE THE CORD HAS BEEN FULLY UNWOUND BEFORE EVERY USE.

OPERATING YOUR SANDWICH MAKER CONT..
7. To maintain heat, keep the sandwich maker lid closed until you are ready to cook the
next sandwich.
8. Prepare additional sandwiches if required while others are cooking.
9. Unplug immediately after use and allow to cool before cleaning.
CAUTION: ENSURE THE CORD HAS BEEN FULLY UNWOUND BEFORE EVERY USE.
FOR BEST RESULTS
1. Always pre-heat the Sandwich Maker before use.
2. For best results butter the outside of the bread before cooking. Flavored butters
may also be used. The outside of the bread may be left unbuttered if required,
however we recommend seasoning the cooking plates occasionally to avoid
sticking. Seasoning will make your Sandwich Maker easier to clean.
To season the cooking plates, pre-heat the Sandwich Maker then gently rub
vegetable oil onto the plates, remove with absorbent paper.
3. Do not use spray on non-stick coatings in your Sandwich Maker as they may
damage the cooking surface.
4. Be careful when biting into sandwiches containing sugar, cheese, tomatoes or jam
as fillings may become very hot and burn.
CARE AND CLEANING
Clean your Sandwich Maker after every use to prevent a build-up of baked-on foods.
Prior to cleaning, ensure the Sandwich Maker has been disconnected from the power
supply and the plug has been removed from the outlet.
Once the Sandwich Maker has cooled, wipe the cooking plates with a soft cloth. If
stubborn baked-on food is present, brush the plates with a small amount of melted
Butter or oil, allow to stand for approximately 5 minutes then wipe again with a damp
cloth.
SUPPORT AND TECHNICAL ADVICE
North Shore City, Auckland, New Zealand
Monday – Friday 8am-5pm
Phone: [phone]
Website: www.goldair.co.nz

Your Goldair product has been inspected and tested and is guaranteed subject to the
following for a period to two years from the date of purchase against defects in
workmanship and materials. During this period, such defects will be rectified by
repair or replacement of the product purchased. Your product contains no user
serviceable components and this warranty becomes invalid if in our opinion the
product has been misused, abused, incorrectly installed, tampered with, connected
to an electrical supply not corresponding with the name plate specification, or
subjected to power surges. The warranty does not include any labour or other
associated expense that may be involved in removal or installation of the product.
Normal wear and tear is expressly excluded.
If your Goldair product fails to operate satisfactorily, please return it to the retailer
from whom it was purchased. To obtain a repair or replacement product under this
warranty, you will need to produce satisfactory evidence of date of purchase. The
completed warranty and purchase receipt must be presented with the product. The
warranty should be filled out at the time of purchase. It is in your interest to make
sure this is done.
If the product is to be replaced (cannot be repaired) then that replacement will be of
the same or similar product or accessory excluding packaging, instruction card etc.
Where a replacement product is supplied, this shall be guaranteed for the balance of
the original warranty period.
Any model that is no longer available will be replaced by a model of a value and with
such features as we consider appropriate in the circumstances. Goldair Ltd is not
responsible for freight forwarding charges, losses or damage in transit.
If service is required after the warranty period has expired, the product should be
returned to a qualified electrical technician. Service outside of the warranty period
will be at your cost.
Consumers Guarantee Act (1993).
In accordance with the above act consumers are advised that: The manufacturer
does not undertake that repair facilities and parts are necessarily available for this
product.
If any of the provisions of the foregoing are contrary to any relevant legislation, then
that provision shall be deemed to be excluded from the warranty and the rest of the
provisions will continue to apply.
TWO YEAR WARRANTY
IMPORTANT: PLEASE RETAIN THIS WARRANTY CARD
NAME:
ADDRESS:
PURCHASED FROM:
SUBURB:
DATE OF PURCHASE:
NAME OF PRODUCT:
MODEL No: .