
3
Sample Xfade Oscillator Mode
On the Oscillator SEL page, it is now possible to set an oscillator in Sample Xfade mode –Xfad.
When switching to Xfade mode, the #Smp parameter will change its name to Chop2, and the
Xfade parameter will become a numeric value.
In Xfade mode, you can select sample A by the Chop parameter on the OSC page, and sample B by
the Chop2 parameter on this page. The numbers selected by these parameters refer to the 4
samples, that is selected on the SMP page. A value of 1-64 will select a chop point in sample 1, a
value of 65-128 will select a chop point in sample 2, a value of 129-192 will select a chop point in
sample 3, and a value of 193-256 will select a chop point in sample 4. If no chop points exists in
the selected sampling, the sampling itself will be selected.
When you have 2 samples selected, you can use the Xfade parameter to crossfade between these.
The Xfade parameter can be modulated by any modulation source. This is explained on the next
page.
Some limitations in Xfade mode:
-The Chop and Chop2 parameters can’t be morphed in this mode. The Xfade parameter can
though be morphed.
-In this mode, digital filter 2 are not available. Filter 1 will though act as a stereo filter.