GPX TE3213B User manual

Customer Support: 1-888-999-4215GPX | TE3213
Quickstart Guide
Setup
AC power: built-in AC power cable It is recommended to gently set the television face down on a table
or other surface when mounting, due to the fragile nature of the
glass stand. Use a philips-head screwdriver to tighten or remove the
screws. Using an power drill could damage the TV stand.
This triangular rubber should
point backward
Front side
bottom
Power
Remote control: requires 2, AAA-size, batteries (included)
OPEN
Remote Power
Connecting the Stand

Customer Support: 1-888-999-4215GPX | TE3213
Quickstart Guide
Television Setup
Connecting a Set-Top Box
Requires a Set-Top Box (not included).
If your Set-Top Box has an HDMI Output:
• Connect the HDMI output on the Set-Top Box to the HDMI INPUT on the
television using an HDMI cable (not included).
If your Set-Top Box has a Composite Video Output:
• Connect the video output on the Set-Top Box to the COMPOSITE VIDEO
INPUT on the television using an A/V RCA cable (not included). Connect the
audio output on the Set-Top Box to the RCA AUDIO INPUT on the television.
If your Set-Top Box has a Component Video Output:
• Connect the component video output on the Set-Top Box to the
COMPONENT VIDEO INPUT on the television using a component RCA cable
(not included). Connect the audio output on the Set-Top Box to the RCA
AUDIO INPUT on the television.
After connecting your Set-Top Box:
• Press the SOURCE button to switch to AV/Component (YPrBr) or HDMI 1, 2 or
3 to match the connection used.
Requires a TV antenna (not
included).
1. Connect a VHF, UHF, or HDTV
antenna to the RF Input on the
television.
2. Press the Source button to switch
to TV mode.
3. Press the Setup button to access
the setup menu.
4. Press the Arrow () buttons to
highlight the CHANNEL icon. Press
the Enter button.
5. Press the Arrow () buttons
to highlight Air/Cable. Press the
Arrow () buttons to select AIR.
6. Press the Arrow () buttons to
highlight AUTO SCAN. Press the
Enter button to begin scanning for
available channels.
Connecting a TV Antenna
Requires a cable connection.
1. Connect a cable to the RF Input on
the television.
2. Press the Source button to switch
to TV mode.
3. Press the Setup button to access
the setup menu.
4. Press the Arrow () buttons to
highlight the CHANNEL icon. Press
the Enter button.
5. Press the Arrow () buttons
to highlight Air/Cable. Press the
Arrow () buttons to select
CABLE.
6. Press the Arrow () buttons
to highlight Auto Scan. Press the
Enter button to begin scanning for
available channels.
Connecting Basic Cable
The Auto Channel Scan must be run before any channels can be viewed on the television.
1. Press the Source button to switch to TV mode.
2. Press the Setup button to access the setup menu.
3. Press the Arrow () buttons to highlight the CHANNEL icon. Press the Enter button.
4. Press the Arrow () buttons to highlight Air/Cable. Press the Arrow () buttons to select AIR.
5. Press the Arrow () buttons to highlight Auto Scan. Press the Enter button to begin scanning for available channels.
Auto Scanning for Channels
Note: Initial channel scanning
process may take up to 15 min.