Graco MAGNUM 289680 User manual

Graco Inc. P.O. Box 1441 Minneapolis, MN 55440-1441
Copyright 2007, Graco Inc. is registered to I.S. EN ISO 9001
312930A
Instructions
Enclosure Replacement Kit for
X5, X7, LTS 15, and LTS 17 Sprayers
This manual contains kit installation instructions only
Enclosure Replacement Kit: 289680, 289681
Pressure Relief Procedure
Important Safety Instructions
For detailed sprayer information and warnings, see
Operation manual 312001 or 313034 included with Magnum sprayers.
To help prevent injection injuries, follow this
procedure when you stop spraying and
before you service or clean the sprayer,
remove parts, or repair leaks.
1. Turn Power switch OFF. Unplug sprayer.
2. Turn Spray/Prime valve to PRIME to relieve pres-
sure. Turn pressure control knob left (counterclock-
wise) to minimize pressure.
3. Trigger gun.
4. Put trigger safety in safety ON position.
NOTE: Leave Spray/Prime valve in the
PRIME position until you are ready to spray
again.
If you suspect that the spray tip or hose is completely
clogged or that pressure has not been fully relieved
after following the steps above, VERY SLOWLY loosen
the tip guard retaining nut or hose end coupling to
relieve pressure gradually. Then loosen it completely.
Clear the tip or hose obstruction.
ti11904a
ti11868a

2312930A
Enclosure Replacement Kit 289680, 289681
Disassembly
1. Unplug electrical cord and Relieve Pressure (see
page 1 or Operation manual 312001).
2. Remove 4 side shroud screws (E) (T-20 Torx).
3. Remove 4 front cover screws (B) (T-30 Torx).
4. X7 and LTS 17 Only: Remove underside shroud
screw (D).
5. Remove right shroud (G).
6. Remove left shroud (K).
7. Remove ON/OFF (L) switch from left shroud (K).
Assembly
1. Install ON/OFF switch (L) into left shroud (K).
2. Install power cord (N) into recess on left shroud (K).
3. Reassemble both shrouds (G and K).
4. Install 4 side shroud screws (E) (T-20 Torx). Torque
to 20 to 25 in-lb (2.3 to 2.8 N•m).
5. Install 4 front cover screws (B) (T-30 Torx). Torque to
26 to 32 in-lb (2.9 to 3.6 N•m).
6. X7 and LTS 17 Only: Install underside shroud
mounting screw (D). Torque to 25 to 35 in-lb (2.8 to
3.9 N•m).
ti10231a
E
K
D
B
G
N
L
All written and visual data contained in this document reflects the latest product information available at the time of publication.
Graco reserves the right to make changes at any time without notice.
GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440-1441
www.graco.com
03/2008