Graco 246388 Operation manual

Instructions – Parts List
GRACO INC.ąP.O. BOX 1441ąMINNEAPOLIS, MNą55440-1441
Copyright 2003, Graco Inc. is registered to I.S. EN ISO 9001
Accessory Hopper Kit for:
Ultra 395/495t
Ultimate Nova 395/SuperNovat495
Ultra Performance 395/495t309825 Rev. A
246388, Series A
Pressure Relief Procedure
WARNING
INJECTION HAZARD
System pressure must be
manually relieved to prevent
system from starting or spraying
accidentally. Fluid under high pressure can
be injected through skin and cause serious
injury. To reduce risk of injury from injec-
tion, splashing fluid, or moving parts,
follow Pressure Relief Procedure when-
ever you:
Dare instructed to relieve pressure,
Dstop spraying,
Dcheck or service any system equip-
ment,
Dor install or clean spray tip.
1. Lock gun safety latch.
2. Turn ON/OFF switch to OFF.
3. Unplug power supply cord.
4. Unlock gun safety latch. Hold metal part of
gun firmly to grounded metal pail. Trigger
gun to relieve pressure.
5. Lock gun safety latch.
6. Open pressure drain valve. Leave pres-
sure drain valve open until ready to spray
again.
If suspected that spray tip or hose is com-
pletely clogged, or that pressure has not been
fully relieved after following steps above,
VERY SLOWLY loosen tip guard retaining nut
or hose end coupling to relieve pressure
gradually, then loosen completely. Now clear
tip or hose obstruction.
TI3143A
5
6
3
8
7
3
4
9
2
1
Ref.
No. Part No. Description Qty.
1 188787 HOPPER, 1.5 gallon 1
2 112133 SCREEN, hopper 1
3 104938 O-RING 1
4 287049 TUBE, inlet, hopper 1
5 15B778 FOOT, hopper 1
6 110883 SCREW, mach, pnh 1
7 15B434 NUT, jam 1
8 117559 O-RING 1
9 109466 NUT, lock, hex 1

2309825
Install
1. Follow Pressure Relief Procedure.
Fig. 1
78
2. Loosen jam nut (78) and remove suction set.
Fig. 2 TI3134A
3. Remove hopper lid. Insert hopper tube into pump.
Fig. 3 TI3150A
4. Tighten jam nut until hopper does not move. Place
drain tube into hopper.
Fig. 4
TI3144A
6
5
5. Loosen screw (6) and position hopper foot (5) until
sprayer feet and hopper foot are level. Tighten
screw.
TO PLACE AN ORDER OR FOR SERVICE, contact your Graco distributor, or call 1–800–690–2894 to identify the nearest distributor.
All written and visual data contained in this document reflects the latest product information available at the time of publication.
Graco reserves the right to make changes at any time without notice.
Sales Offices: Minneapolis, Detroit
International Offices: Belgium, Korea, Hong Kong, Japan
GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440–1441
http://www.graco.com
PRINTED IN USA 309825 01/2003