6 / 24 16530_jh_V1
Symbols explication
Always follow the information marked with the CAUTION or WAR-
NING symbol. The signal word WARNING indicates the potential
for serious injury, the signal word CAUTION indicates possibility of
lighter injuries.
The NOTE is an important information that warns you about pos-
sible material damages.
Gluing instruction 2C This symbol shows that 2 components glue
must be used. Pay attention to the hazard notices on the
package.
Thread lock This symbol shows that thread lock must be used.
Pay attention to the hazard notices on the package.
Soldering instructions this symbol shows that it is necessary
to solder some parts.
Shrink tube instruction This symbol shows that it is necessary
to isolate with shrink tube.
Safety notes
WARNING
This safety notes are intended to protect you and other people.
They are also used for safe handling the product. Therefore
please read this section very carefully before using the product!
Do not carelessly leave the packaging material lying around,
since it might become a dangerous toy for children.
Persons, including children, with reduced physical, sensory or
mental capabilities, or lack of experience or knowledge, or not
capable to assemble and use safely the 3D COPTER must not
use the 3D COPTER without supervision or instruction by a res-
ponsible person.
Operation and use of radio-controlled models needs to be learnt!
If you have never operated a model of this type before, start
carefully and make yourself familiar with the model‘s reactions
to the remote control commands. Proceed responsibly.
First, always perform a range and function test on the ground
(to do so, hold your model tight), before you use your model.
Repeat the test with running motor and with short throttle bursts.
Before you start using the remote control model, you have to
check the further relevant laws and regulations. These laws you
must obey in every case. Pay attention to the possibly different
laws of the countries.
