Great day QUICK DRAW QD805 BF User manual

PAGE 1 OF 5
“QUICK DRAW” BOW FISHING RACK
MODEL# QD805 BF
READ ALL INSTRUCTIONS BEFORE USING THE BOW RACK
NOTE: Failure to read instructions before use could result in injury or death.
Instructions for Installation and Use:
CONTENTS
BOW RACK (WITH QUICK ATTACH
PLATE INSTALLED)
4- ¼” X 1” BOLTS
4- ¼” X 1 ¾” BOLTS
4- ¼” LOCKNUTS
4- ¼” FENDER WASHERS
4- ¼” FLAT WASHERS
2- 15” BUNGEES
**NOTE** YOU WILL NEED A
DRILL WITH A 9/32” DRILL BIT FOR
INSTALLATION

PAGE 2 OF 5
FIG.1
FIG.2
FIG. 3 FIG. 4
1) CHECK TO ENSURE ALL
CONTENTS ARE ENCLOSED.
2) REMOVE QUICK DETACH
PLATE FROM BOW RACK BY
LOOSENING 4 WING KNOB
SCREWS. (FIG. 1)
3) SELECT DESIRED MOUNTING
LOCATION. MARK HOLE FOR
DRILLING. **NOTE** WHEN
SELECTING LOCATION, MAKE SURE
SURFACE IS STRUCTURALLY
STABLE, IS ACCESSIBLE FROM
UNDERNEATH, AND IS FREE FROM
ANY OBSTRUCTIONS; I.E. WIRES,
HOSES, ETC. (FIG. 2)
4) DRILL HOLES USING A 9/32” DRILL BIT. ATTACH PLATE USING
APPROPRIATE HARDWARE. (FIG. 3 & 4) **NOTE** USE FENDER
WASHERS ON UNDERSIDE OF MOUNTING SURFACE. (FIG. 5)

PAGE 3 OF 5
FIG. 5
TO LOAD BOW INTO RACK
1) STANDING IN FRONT OF RACK, PLACE LOWER LIMB OF BOW BETWEEN
APPROPRIATE SET OF PINS. (FIG.1 & 2)
FOR COMPOUND AND LEVER LIMB BOWS
FOR PARALLEL LIMB BOWS
FIG. 1
FIG. 2
5) RE-ATTACH BOW
RACK TO PLATE
USING 4- WING
KNOB SCREWS.
(FIG. 1)

PAGE 4 OF 5
FIG. 3
FIG. 4
FIG. 5
2) WHILE HOLDING BOW WITH
ONE HAND, PRESS DOWN ON
TOP HANDLE TO MOVE TENSION
FORKS INTO POSITION TO LOAD
TOP LIMB OF BOW. (FIG. 3)
3) ONCE BOW IS PROPERLY
POSITIONED IN BOTTOM PINS AND TOP
TENSION FORKS, RELEASE HANDLE.
BOW SHOULD BE HELD BY TENSION IN
RACK AT THIS TIME. (FIG. 4) **NOTE**
TO ADJUST BOW IN RACK, DEPRESS
HANDLE, MOVE BOW TO CORRECT
POSITION, AND RELEASE HANDLE.
4) SECURE VELCRO STRAP
AROUND BOW RISER FOR
EXTRA SECURITY. (FIG.5)

PAGE 5 OF 5
•NEVER INSTALL QD805 WHERE IT IMPEDES OPERATORS VISION.
•NEVER INSTALL ON SURFACE THAT IS NOT STRUCTURALLY SOUND.
•NEVER USE “QUICK DRAW” BOW RACK TO CARRY ANYTHING
OTHER THAN BOWS, I.E. GUN(S), KAISER BLADES, SHOVELS, ETC..
●MAKE SURE BOW(S) ARE PROPERLY SECURED BEFORE MOVING
VEHICLE.
● NEVER TRY TO REMOVE BOW(S) FROM THE “QUICK DRAW” BOW
HOLDER WHILE OPERATING VEHICLE.
For more information about this or other products, contact us at:
Great Day, Inc.
604 Kimbrough Dr. * Tallulah, LA 71282 * [phone] *
www.greatdayinc.com